Publicidad
Idiomas disponibles
Idiomas disponibles
Depending on the speci¿ c size & weight of the plas-
9
ma, articulating swing arm may be angled at different
positions, causing plasma to appear to lean sideways
at different articulating positions. Tilt-roll assembly (B)
allows plasma to be manually adjusted, so plasma
can be horizontal at all positions. To adjust, gently
rotate plasma by hand to desired position.
ARTICULATING
ARM
FOR PLAV60 ONLY:
10
Position of display may be adjusted vertically up to .79" in
each direction by doing the following:
• To lower display, turn socket screw shown in ¿ gure 10.1
clockwise with 10mm allen wrench (V).
• To raise display, turn socket screw shown in ¿ gure 10.1
counterclockwise with 10mm allen wrench (V).
SOCKET
SCREW
PLASMA
fi g. 10.1
If it is too dif¿ cult to adjust roll of plasma, loosen
9-1
screws shown in ¿ gure 9.1 using a phillips screw-
driver.
IMPORTANT! Do not loosen or tighten screws
more than 1/8 turn.
ISSUED: 06-05-06 SHEET #: 202-9141-9 04-30-11
13 of 41
All other brand and product names are trademarks or registered trademarks of their respective owners.
ROLL
ADJUSTMENT
SCREWS
fi g. 9.1
© 2011, Peerless Industries, Inc. All rights reserved.
Publicidad
