Wiring For Gigabit Slide-In Module; Console Port - Longshine LCS-SW1420S Manual Del Usuario

Wiring for Gigabit Slide-in Module

Following are the summaries of cabling required:
Media
Gigabit copper
Gigabit Fiber SC

Console Port

The RS-232 console is an interface for connecting a terminal directly. Through
the console port, it provides rich diagnostic information includes network
statistics, link status and system setting. The operating mode of the console
port is:
DCE
9600 (Fix baud rate)
n (No parity checking)
8 (8 Data bits)
1 (1 stop bit)
None (No flow control)
You can use a normal RS-232 cable and connect to the console port on the device. After
the connection, you can run any terminal emulation program (Hyper Terminal,
Winterm, Telix, ... and so on) to enter the startup screen of the device. All the detail
software operation, please refer to "Console port (out-of-band) connection" session of
chapter 5.
Speed Wiring
10Mbps Category 3,4,5 UTP/STP
100Mbps Category 5 UTP/STP
1000Mbps Category 5 UTP/STP
1000Mbps Fiber SC
E-15