Module Installation; Management Stack - Longshine LCS-SW1420S Manual Del Usuario

4.4 Module Installation

The two slide-in slots on the rear panel are purposed for installing optional
modules. They can be used as a network backbone or connect to a server. Follow
the steps as described to install a module:
1. Power off the switch
2. Removing the two screws on the face plate of slide-in slot with a flat-head
screwdriver
3. Push the module gently into the slot along the slide tracks
4. Ensuring that it firmly engages with the connector then tighten the screws to
secure the module
Attention The slide-in slots are not hot swappable, power off the switch
before installing modules

4.5 Management Stack

There are two RJ-45 ports on the front panel for proprietary management stack.
Only straight-through UTP/STP cable can be used.
Plug one end of the cable in the "IN" port and the other end to the "OUT" port of
next device. Repeat the step for every device in the stack cluster, then ending at
last switch.
Attention Before management stacking, be sure of every device uses a
unique "HUB ID", or the management stack will not work
E-19