Waterpik WP-130 Instrucciones De Uso página 7

Prime Unit (First Time Use Only)
Set pressure control dial on base to high (pressure
setting No.10), point the handle and tip into sink.
Turn power and water ON until water flows from
the tip. Turn unit OFF.
ON
High
Adjusting the Pressure Setting
Turn the pressure control dial on the base of the
unit to the lowest setting (pressure setting No.1)
for first-time use. Gradually
increase pressure over
time to the setting you
prefer – or as instructed by
your dental professional.
Using the Water Flosser
Always place the tip in your mouth before
turning the water ON. With water switch on
handle in OFF position, turn power on. Lean over
sink and slightly close lips enough
to prevent splashing while still allowing
water to flow from mouth into
the sink.
Water
ON
Low
Turn water switch ON.
When finished, turn water
switch and power OFF.
During use you can stop the
flow of water by sliding the
water switch on handle to the
OFF position.
NOTE: Motor will continue to run.
Recommended Technique
For best results,
start with back teeth
and work toward the
front teeth. Direct the
stream at a 90-degree angle to your gumline with
tip in mouth. Glide tip along gumline and pause
briefly between teeth. Continue until you have
cleaned the inside and outside of both the upper
and lower teeth. Lean over sink.
When Finished
Turn the unit off. Empty any liquid left in the
reservoir.
Note: If you used mouthwash or other solution
besides water, see "Using Mouthwash and Other
Solutions" section.
7
Water
OFF