Changing The Batteries - Beurer medical FT 65 Manual De Instrucciones

Measuring surface temperature
• Press the button for 1 second to switch the thermometer on. Following a successful self test, the device emits two
short beeps.
• Then press the and
The symbol appears in the display.
• Press and hold the
(never immerse in liquids), maintaining a distance of 3 cm.
• Release the button or
value appears on the display.
Please note that the displayed temperature is the measured and not the adapted surface temperature. It is not the same as
the forehead/ear temperature.
To switch back to the Ear/Forehead thermometer mode, press the
the symbol disappears and there is a short beep. By switching the thermometer off and on again, it automatically exits
the Object temperature mode.
The temperature last measured, i.e. only the last value of a series of measurements, is automatically stored as soon as the
thermometer switches itself off or is switched off. There are 10 storage spaces available for this.
To switch the thermometer off, press the
If you do not take any further measurements, the thermometer switches itself off automatically after approx. one minute
after the measured values have been displayed.
To call up the saved values, switch the thermometer on and press the
The date, time, storage space number, the measurement mode symbol and the temperature are displayed in turn. Browse
through the stored measurements by pressing the

8. Changing the batteries

When the batteries get weak, the battery warning symbol appears
batteries must be replaced. When the battery symbol flashes
replaced. If the batteries are too flat, then the thermometer will switch off automatically.
buttons simultaneously for 3 seconds to switch to the Object temperature mode.
button or Forehead and point the sensor tip towards the object or liquid to be measured
Stirn
Forehead. The end of the measuring time is signalled with a short beep and the measured
Stirn
and Forehead buttons simultaneously for approx. three seconds.
Stirn
and buttons simultaneously for 3 seconds until
button.
button repeatedly.
. It is still possible to measure temperature. The
and appears in the display, the batteries must be
25