46260.5P.02
Specifications
Element
Downlink ports
Uplink ports
Network standard
Switching capacity
Package forwarding speed
Type of exchange
MAC address list
Standard PoE
PoE mode
PoE power supply
PoE output
CCTV mode
Immunity to transient overvoltages
Protection from electrostatic discharge (ESD)
Switch input voltage
Power supply input voltage
Power consumption
Operating temperature
Storage temperature
Operating humidity
Size (LxDxH)
Material
Weight
Troubleshooting
Run the following checks in the event of incorrect operation:
- Check that the installation is correct;
- Check that the order of the RJ45 cable conductors conforms to industrial standards EIA/TIA 568A or 568B;
- The electrical power supply from each PoE port does not exceed 30 W; do not connect a PoE device with greater power than the
maximum PoE electrical power supply;
- Replace a faulty device with a correctly operating one to check if the device is faulty;
- If the problem persists, contact the technical assistance service.
Description
4 10/100/1000 Base-T (PoE)
1 10/100/1000 Base-T
IEEE 802.3/IEEE802.3u/IEEE802.3ab/IEEE802.3x
10 Gbit/s
7.44 Mp/s
Store and Forward
2K
802.3af/at(PSE)
End-span
1/2(+) , 3/6(-)
PoE power per single port ≤30 W (54Vcc),
Total available PoE power ≤60 W
The downlink ports communicate only with the uplink ports
6 kV: IEC61000-4-5
Contact discharge 6 kV, Air discharge 8 kV, according to: IEC61000-4-2
54 Vdc - 1.11 A,
100-240 V, 50/60 Hz, 2 A
5 W
-10 °C ~+55 °C
-40 °C ~+85 °C
5%-95% (non-condensing)
135 mm×85.6 mm×27 mm
Metallic
315 g
EN
7