Skil PWRCORE 20 RS5825B-00 Manual Del Propietário página 12

To attach/detach battery pack
Lock the variable-speed trigger switch "OFF"
on the tool by depressing the lock-off button to
the locked position
To attach the battery pack:
Align the raised rib on the battery pack with the
grooves on the tool, and then slide the battery
pack onto the tool (Fig.3).
To detach the battery pack:
Depress the battery-release button, located
on the front of the battery pack, to release the
battery pack. Pull the battery pack out and
remove it from the tool (Fig.3).
NOTICE: When placing the battery pack on the
tool, be sure that the raised rib on the battery pack aligns with the groove inside the tool and
that the latches snap into place properly. Improper attachment of the battery pack can cause
damage to internal components
WARNING
not in use or when carrying it at your side.
Variable-Speed Trigger Switch
Your tool is equipped with a variable-speed
trigger switch. The tool can be turned "ON" or
"OFF" by depressing or releasing the trigger.
The variable-speed trigger switch delivers
higher speed with increased trigger pressure
and lower speed with decreased trigger
pressure (Fig.4)
Dual LED Lights (Fig .5)
Your tool is equipped with Dual LED lights,
located below and above the blade clamp of the
tool. This provides additional light on the surface
of the workpiece for operation in lower-light
areas.
The LED light will automatically turn on with a
slight squeeze on the variable-speed trigger
switch before the tool starts running and will turn
off approximately 10 seconds after the variable-
speed trigger switch is released.
12
.
Battery tools are always in operating condition. Therefore, the lock-off
button should always be depressed in the locked position when the tool is
Fig. 3
Attach
Fig. 4
Fig. 5
Battery-Release
Button
Detach
Variable-Speed
Trigger Switch
Dual LED Lights