Product Specifications; Assembly; Installing The Blade - QEP 22750Q Instrucciones De Funcionamiento

FIGurE 3

PrOdUCt SPeCiFiCatiOnS

Input: 4.8 Amps
No-load Speed: 3600 rpm
Output: 3⁄4-peak hp
Blade Diameter: 7 in. (180 mm)
Arbor: 5/8 in.
Rating: 120 volts~60 hz Ac
Depth of Cut: 1 1⁄4 in. (31 mm)

ASSEMBLY

ASSEMBLY AND OPERATION INSTRUCTIONS
COMPLETELY BEFORE CONNECTING THE
SAW TO A POWER SOURCE OR TURNING THE
MOTOR ON.
UnPaCKinG
1 . Remove all packing materials from around
your saw .
2 . Carefully lift the saw from carton and place
it on a level work surface .
3 . Do not discard the packing materials until
you have carefully inspected the saw for
loose or damaged parts .
FOLLOW ALL OF THE
The following items are included in box with
your tile saw:
• Tile Wet Saw
• Rear Extension Table
• 7 in. Diamond Blade
• Blade guard
• Rip Guide
• Angle Cutting Guide
• Rear Support
• Owner's Manual
4 . Inspect the saw carefully to make sure
that no breakage or damage has occurred
during shipping . If any parts are damaged or
missing, please call QEP Customer Service
at 866-435-8665
DAMAGED OR MISSING, DO NOT ATTEMPT
TO OPERATE THIS SAW. OPERATING THIS
SAW WITH DAMAGED OR MISSING PARTS
COULD RESULT IN POSSIBLE SERIOUS
PERSONAL INJURY.

inStaLLinG tHe BLade

1 . Remove right cutting table .
2. Remove baffle (see FIGURE4)
– 5 –
IF ANY PARTS ARE