KOBE RA2230SQB-1 Instrucciones De Instalación Y Manual De Operación página 10

Ocultar thumbs Ver también para RA2230SQB-1:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Ductwork Installation
5. Using
Reference
measurements on Page 13, mark the leveling point
for duct cover-mounting bracket.
6. Secure the duct cover-mounting bracket to the wall
with two screws (provided). (Figure 5 and Figure 8)
Make sure all screws are tightened. NOTE: Inner
duct cover will cover the duct cover-mounting
bracket.
7. Use 6" steel pipe (not provided) to connect the
plastic exhaust on the hood to the ductwork above.
Use duct tape to ensure all joints are secure and air
tight as shown in Figure 6.
Wiring to Power Supply
THIS RANGE HOOD MUST BE PROPERLY
GROUNDED. MAKE SURE THIS IS DONE BY
QUALIFIED ELECTRICIAN IN ACCORDANCE
WITH ALL APPLICABLE NATIONAL AND
LOCAL
ELECTRICAL
CONNECTING WIRES, SWITCH POWER OFF
AT SERVICE PANEL AND LOCK SERVICE
PANEL TO PREVENT POWER FROM BEING
SWITCHED ON ACCIDENTALLY.
8. Connect three wires (black, white and green) to
house wires and cap with wire connectors.
Connect according to color: black to black, white to
white, and green to green.
9. Test the operation of the hood before performing
the next step. Make sure power is supplied to the
hood.
Duct Cover Installation
10. Slide inner duct cover up 2 inches before sliding
entire duct cover onto the hood. (Figure 7)
11. Align the inner duct cover to the duct cover-
mounting bracket. Secure inner duct cover with two
(3/16" x 3/8") screws (provided).
12. Fasten outer duct cover to plastic plate on the hood
with four (3/16" x 3/8") screws (provided).
Accessories Installation
13. Place baffle filters underneath the hood.
E
from
Table
1
CODES.
BEFORE
Final Assembly
and
14. Turn power ON in control panel. Check all
lights and fan operation.
15. Leave this Installation Instructions and
Operation Manual for the homeowner.
Figure 5
Figure 6
Figure 7
8

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ra2236sqb-1

Tabla de contenido