Error Mode - LG GCWL1069CS4 Manual De Instrucciones

82

ERROR MODE

ERROR MODE
Meaning of Error Codes that LED displays during occurrence of problem.
Problem
• Water supply is not adequate in area.
• Water supply taps are not completely
open.
• Water inlet hose is bent.
• The filter of the inlet hose clogged.
• Drain hose is bent
or clogged.
• The drain filter is clogged.
• Load is too small.
• Load is out of balance.
• The appliance has an imbalance detection
and correction system. If individual heavy
articles are loaded (bath mat, bath robe,
etc.) and the imbalance is too great, after
several attempts to restart the spin cycle
the machine will stop and the error code
will be displayed.
• Is the door opened or not completely
closed?
• Door lock is broken.
• The water overfills due to a faulty water
valve.
• The water level sensor malfunction.
• Overload in motor.
• Disconnection of card reader cable.
• Thermistor is opened or shorted.
• Out of balance sensor is defective.
Possible Cause Solution
Check another tap in the house.
Fully open tap.
Straighten hose.
Check the filter of the inlet hose.
Clean and straighten the drain hose.
Clean the drain filter.
Add 1~2 similar items to help
balance the load.
Rearrange load to allow proper spinning.
Close the door completely.
✽ If it will not open, call for service.
Check the door switch.
Close the water tap.
Unplug the power plug.
Call for service.
Restart the cycle after 30 minutes.
If is not released, call for service.
Check the card reader wire.
Thermistor should be replaced.
Sensor should be replaced.