Before Starting The Equipment - Toolson PRO-WSA 2300 S Manual De Instrucciones Original

Anleitung_PRO_WSA_2300_S_SPK7:_
Total vibration values determined in accordance with
EN 60745.
Surface grinding
Vibration emission value a
hAG
K uncertainty = 1.5 m/s 2
Additional information for electric power tools
Warning!
The specified vibration value was established in
accordance with a standardized testing method. It
may change according to how the electric equipment
is used and may exceed the specified value in
exceptional circumstances.
The specified vibration value can be used to compare
the equipment with other electric power tools.
The specified vibration value can be used for initial
assessment of a harmful effect.
Keep the noise emissions and vibrations to a
minimum.
Only use appliances which are in perfect working
order.
Service and clean the appliance regularly.
Adapt your working style to suit the appliance.
Do not overload the appliance.
Have the appliance serviced whenever
necessary.
Switch the appliance off when it is not in use.
Wear protective gloves.
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain residual
risks cannot be rules out. The following hazards
may arise in connection with the equipment's
construction and layout:
1. Lung damage if no suitable protective dust mask
is used.
2. Damage to hearing if no suitable ear protection is
used.
3. Health damage caused by hand-arm vibrations if
the equipment is used over a prolonged period or
is not properly guided and maintained.
18.03.2010 14:30 Uhr

6. Before starting the equipment

Before you connect the equipment to the mains
supply make sure that the data on the rating plate
= 5.835 m/s 2
are identical to the mains data.
6.1 Fitting the additional handle (Fig. 2)
The angle grinder must not be used without the
additional handle (4).
The additional handle can be secured in any of
three positions (A, B, C).
Left (position A / as
shown)
Right (position B)
Top (position C)
6.2 Adjusting and changing the safety device
(Fig. 3)
Pull out the power plug.
Switch off the tool. Pull the power plug.
Adjust the guard (5) to protect your hands so that
the material being ground is directed away from
your body.
The position of the guard (5) can be adjusted to
any specific working conditions. Undo the clamp
handle (a) and turn the cover (5) into the
required position.
Ensure that the guard (5) correctly covers the
gear wheel casing.
Secure the clamp handle (a) again.
Ensure that the guard (5) is secure.
To remove the safety device, open the clamp
lever (a) and turn the safety device until it can be
taken off.
To attach the safety device, proceed in reverse
order with instructions for removing the safety
device.
Take care that the safety device is secure.
Never use the angle grinder without the
guard.
6.3 TEST RUN FOR NEW GRINDING WHEELS
Allow the right-angle grinder to run in idle for at least
1 minute with the grinding or cutting wheel fitted in
place. Vibrating wheels are to be replaced
immediately.
Seite 11
Tool side Suitable for
Right-handed users
Left-handed users
Using cutting wheels
GB
11