Adjusting The Yoke; Wiring; Voltage - LDR Tango 1500msr FF Instrucciones De Manejo

5. ADJUSTING THE YOKE
This followspot is provided with a yoke balancing adjustment. The balancing point is factory set for
the standard product configuration supplied with colour changer. However, should you need to
adjust the balancing, please follow the procedure here below.
Two persons, one at the front and one at the back of the followspot are needed to perform this
operation
• Mount the followspot on the tripod stand with all relevant accessories attached.
• Using a Phillips screw driver, loosen the 3 M5 screws on each side of the yoke.
• Gently slide the followspot backwards or forwards to the required position.
• Make sure the yoke is correctly aligned horizontally.
• Tighten the 6 M5 screws
6. WIRING
Before being connected to the mains power, this unit may need to be wired with a suitable plug if
not already installed. Make sure the plug you are using is rated for the proper power load and it
conforms to the relevant EU/UL o local electrical standards.
• Make sure the plug you are fitting withstands the lamp power load.
• This fixture must be grounded
• To perform a correct wiring, please note that the cores in this mains lead are colour‐coded as
follows:
In case the colours of the wires do not correspond to the colour of the connection points on
your plug, please proceed as follows:
• The green or green and yellow wire must be connected to the connection point marked
with the letter E or with the symbol or coloured in green or in green‐yellow
• The blue wire must be connected to the connection point marked with the letter N or with
the symbol or coloured in black
• The brown wire must be connected to the connection point marked with the letter L or
with the symbol or coloured in red
• Before you finally position this product for use, temporarily connect it to a properly fused
power supply to check the lamp works correctly.
7. VOLTAGE
Before operating this unit please refer to the product label mounted on the ballast unit to check
you are operating with the correct voltage.
Tel. +39 0376 771 777 – fax +39 0376 772 140 – email info@ldr.it – web www.ldr.it
LDR TANGO 1500msr FF User's manual – 1.1
Ground: green+yellow – Neutral: blue ‐ Hot: brown
Luci della Ribalta srl, Via Berna 14, 46042 Castel Goffredo (MN) Italy
6