Directions For Use - Guardian Technologies Pureguardian H910BL Instrucciones De Uso Y Cuidado

DIRECTIONS FOR USE

SET Up
Select a firm, level, flat location - at least six inches (15 cm) from any wall or object for proper air
flow. Place the humidifier on a water-resistant surface, as water can damage furniture and some
flooring. Do not place unit directly on carpet, towels, blankets or other absorbent surfaces.
Guardian Technologies will not accept responsibility for damage caused by water spillage.
FILLING
Make sure unit is unplugged.
1. Separate the tank from the base of the unit.
2. Open the tank lid, turning it
to the left.
4. Close the tank lid, turning it to the
right. It is important to FIRMLY secure
cap after filling the tank with water.
6. Press the Power Button to turn on.
*See Mode Chart for further operating
instructions.
E-6
3. Pour cool, clean water directly
into the tank. Do not pour anything
but water into the tank.
BACk OF UNIT
5. Plug Power Adapter into back of
humidifier unit. Plug into outlet.
NOTE: If you live in a hard-water area, we
recommend the use of distilled water for
your humidifier. This will help reduce the
precipitation of minerals or 'white dust'.
CLEANING
CLEANING
• Always unplug the unit before servicing in any way.
GENERAL CLEANING
• Inside the base of the unit. Pour excess water out of the unit. Wash out the unit with fresh
water using the cleaning brush and a soft cloth as needed. Do not submerse the base of the
unit into water, or allow water to enter inside the dry air exhaust port of the unit.
• Water tank. Empty water tank. Remove mist nozzle and clean the mist tube with fresh water
and a light brush (bottle cleaning brush is recommended).
• Outer surface of the unit. Wipe the surface of the unit with a soft, damp cloth if needed. If
you notice an accumulation of water during usage, reduce humidity and dry outer surface with
a cloth.
DESCALING
• Depending on usage and water type, cleaning to remove scale may be required
weekly or every other week to optimize unit performance.
• If you live in a hardwater area, we recommend the use of distilled water for your
humidifier. This will help reduce the precipitation of minerals or 'white dust'.
• Do not clean the unit or water tank with detergents or cleaning chemicals of any kind.
ULTRASONIC DISk
1. Unplug unit.
2. Remove the tank and empty all water from unit base and tank.
3. Locate the ultrasonic disk on the inside center of the base unit.
4. Use ONLY the enclosed cleaning brush to gently clean disk and remove build up and deposits.
Do not scrub or scrape the ultrasonic disk.
If scale becomes difficult to remove with brush:
1. Fill the Base with: mixture of 1 tsp. white vinegar and 1 tsp. water.
2. Let solution stand for 5 minutes.
3. With the vinegar in the Base, clean all interior surfaces with a soft cloth or brush to help
remove scale.
Ultrasonic Disk
*Clean the disk with the
brush only. No other
cleaning tool should
be used. BRUSH ONLY.
E-7