Maintenance Schedule; Troubleshooting; Technical Data - Dolmar HT-CS 1 Instrucciones De Manejo

Maintenance schedule

Operating hour
Whole unit
All fixing screws and nuts
Blades
Gear case
Drive axle
Power unit

Troubleshooting

Problem
The motor does not start.
The motor stops soon after its start.
The maximum speed is limited.
The blades do not move.
Stop the motor immediately!
The unit vibrates abnormally.
Stop the motor immediately!
The blades do not stop.
Stop the motor immediately!

Technical data

Dimensions (L x W x H)
Mass
Effective cutting length
Cutting blade angle
Gear ratio
Visually inspect for damaged
parts
Tighten
Inspect for damage, crack and
dull edge
Adjust the clearance
Supply grease
Supply grease
Refer to the instruction manual of the power unit
Refer to the instruction manual of the power unit.
Inappropriate angle of cutter unit.
A twig is caught by the blades.
The drive system does not work properly.
The drive system does not work properly.
The power unit does not work properly.
Model
Before Daily
Operation (10 h)
Probable cause
9
If
25 h Corresponding page
required
Solution
Make sure the angle lock engages properly.
Remove the foreign matter.
Ask Dolmar authorized service center to
inspect and repair it.
Ask Dolmar authorized service center to
inspect and repair it.
Refer to the instruction manual of the power
unit.
HT-CS 1
mm 1,624 x 108 x 90
kg 2.7
mm 490
135° (up 45°, down 90°)
1/4.78
8
8
8
8
8
8