Troubleshooting - Heiniger Saphir/H Instrucciones De Uso

7

Troubleshooting

y The here described tasks for troubleshooting can be done mostly by the
operator.
y Some tasks only may be done by especially trained personal or by an
authorised service centre. These tasks are marked with (S).
Malfunction
Top blade does not
move
Clipper cuts badly
or not at all
Motor is not
running
Motor does not
work
Motor runs very
slowly
Running time of
a fully charged
battery is too short
and / or blades are
getting hot
The control light
of the charging
station in not on
Instruction Manual / Small animal clipper
Cause
Clipperhead is not well
engaged
Turning lever is defective Replace turning lever (S)
Clipper blade is blunt
Clipper blades have not
been correctly ground
Clipper blades are not
oiled
The animal's hair is wet
Hairs jammed between
top and bottom blades
Clipperhead has too little
clipping pressure
Battery is dead
Contacts dirty
Faulty battery
Smell of burning from
the motor housing. Motor
burned out
Faulty motor and / or
electronics
Clipperhead blocked
Clipper blades were not
oiled sufficiently
Clipper blades were not
oiled sufficiently
Dead, not fully charged
or defective battery has
been used
Charging station is not
connected to the power
supply
Charging station is faulty Have charging station inspected (S)
Rectification
Engage the clipperhead correctly
when the motor is running
Have top and bottom blades re-
sharpenend by service centre (S)
Oil clipper blades every 15 minutes
Only clip dry hair
Take off clipperhead, push the top
blade half away from the clip-
perhead, take away hairs between
top and bottom blade
Have clipperhead inspected (S)
Charge battery
Switch clipper off and clean the
contacts
Replace battery
Have motor and / or electronics
replaced (S)
Have motor and / or electronics
replaced (S)
Clean and oil clipperhead
Oil clipper blades
Oil clipper blades
Only use intact and completely
charged original battery
Connect the charging station to
the power supply
17