Troubleshooting - Heiniger Saphir Cord Traducción Del Manual Original

7

Troubleshooting

y The here described tasks for troubleshooting can be done mostly by the
operator.
y Some tasks only may be done by especially trained personal or by an
authorised service centre. These tasks are marked with (S).
Malfunction
Top blade does not
move
Clipper cuts badly or
not at all
Motor is not running
Motor does not work
Motor runs very slowly Clipper blades were not
Translation of the original instructions / Small animal clipper
Cause
Clipper head is not well
engaged
Turning lever is defective
Clipper blades are blunt
Clipper blades have not
been correctly ground as
per specification
Clipper blades are not oiled Oil clipper blades every 15 minutes
The animal's hair is wet
Hairs jammed between top
and bottom blades
Clipper head has too little
clipping pressure
Contacts dirty
Smell of burning
the motor housing. Motor
burned out.
Faulty motor and / or elec-
tronics
Clipper head blocked
oiled sufficiently
Rectification
Engage the clipper head correctly
when the motor is running
Replace turning lever (S)
Have top and bottom blades resharp-
enend by service centre (S)
Only clip dry hair
Take off clipper head, push the top
blade half away from the clipper
head, take away hairs between top
and bottom blade
Have clipper head inspected (S)
Switch clipper off and clean the con-
tacts of the clipper and the battery
from Have motor and / or electronics re-
placed (S)
Have motor and / or electronics re-
placed (S)
Clean and oil clipper head
Oil clipper blades
13