Makita LS1214 Manual De Instrucciones página 11

socket wrench to tighten the hex bolt (left-handed)
securely counterclockwise while pressing the shaft lock.
2 1
002021
CAUTION:
The black ring 25 mm in outer diameter and the
•
silver ring 25.4 mm in outer diameter are
factory-installed as shown in the figure. When
using a blade with 25 mm hole diameter, replace
the silver ring with the black ring. Before mounting
the blade onto the spindle, always be sure that the
correct ring for the arbor hole of the blade you
intend to use is installed between the inner and
outer flanges.
1
2
3
004058
Return the blade guard and center cover to its original
position. Then tighten the hex bolt clockwise to secure
the center cover. Release the handle from the raised
position by pulling the stopper pin. Lower the handle to
make sure that the blade guard moves properly. Make
sure shaft lock has released spindle before making cut.
2
3
002019
1. Blade case
4 3
2. Arrow
3. Saw blade
4. Arrow
1. Inner flange
5
2. Spindle
6
3. Ring
4. Saw blade
5. Outer flange
6. Hex bolt
(left-handed)
4
1. Center cover
2. Hex bolt
1
3. Socket wrench
4. Blade guard
4
Dust bag (accessory)
1
2
001536
The use of the dust bag makes cutting operations clean
and dust collection easy. To attach the dust bag, insert
the dust nozzle into the dust spout on the blade case
and fit the bag's entry port over the dust nozzle.
When the dust bag is about half full, remove the dust
bag from the tool and pull the fastener out. Empty the
dust bag of its contents, tapping it lightly so as to remove
particles adhering to the insides which might hamper
further collection.
NOTE:
If you connect a vacuum cleaner to your saw, more
efficient and cleaner operations can be performed.
Dust box (accessory)
3
006793
Insert the dust box into the dust nozzle.
Empty the dust box at the earliest possible.
To empty the dust box, open the cover by pushing the
button and throw away sawdust. Return the cover to the
original position and it locks. Dust box can easily be
removed by pulling out while turning it near the dust
nozzle on the tool.
NOTE:
If you connect a Makita vacuum cleaner to this tool,
•
more efficient and cleaner operations can be
performed.
CAUTION:
Empty the dust box before collected sawdust level
•
reaches the cylinder part.
11
1. Dust nozzle
2. Dust bag
3. Fastener
3
1. Dust box
1
2. Cover
3. Button
2