Makita LS1214 Manual De Instrucciones página 20

1
3
001558
1
3
001559
Fig. B: At right 45° miter angle
Fig. C: At left 45° miter angle
Position crown molding with its WALL CONTACT
EDGE against the guide fence and its CEILING
CONTACT EDGE against the crown molding
stoppers as shown in the figure. Adjust the crown
molding stoppers according to the size of the
crown molding. Tighten the screws to secure the
crown molding stoppers. Refer to the table (C) for
the miter angle. Use the sub-fence R to secure the
crown molding more firmly.
2
1 3
001560
Position in
Miter angle
Fig. A
(1) Right 45°
For inside
corner
(2)
Left 45°
(3)
For outside
corner
(4) Right 45°
006365
1. Crown molding
2
stopper L
2. Crown molding
stopper R
3. Turn base
1. Crown molding
2
stopper L
2. Crown molding
stopper R
3. Turn base
1. Guide fence
2. Crown molding
4
3. Crown molding
stopper
4. Screw
Table (C)
Finished piece
Save the right side of blade
Save the left side of blade
Save the right side of blade
Save the left side of blade
1. Cutting aluminum extrusion
001844
1
2
004073
When securing aluminum extrusions, use spacer
blocks or pieces of scrap as shown in the figure to
prevent deformation of the aluminum. Use a
cutting lubricant when cutting the aluminum
extrusion to prevent build-up of the aluminum
material on the blade.
CAUTION:
Never attempt to cut thick or round aluminum
•
extrusions. Thick aluminum extrusions may come
loose during operation and round aluminum
extrusions cannot be secured firmly with this tool.
2. Wood facing
Use of wood facing helps to assure splinter-free
cuts in workpieces. Attach a wood facing to the
guide fence using the holes in the guide fence and
6 mm (1/4") screws.
See the figure concerning the dimensions for a
suggested wood facing.
Over 15mm (9/16")
1
72mm
(2-13/16")
1. Hole
005233
20
1. Vise
2. Spacer block
1
3. Guide fence
2 4. Aluminum
extrusion
5. Spacer block
3
4
5
1. Aluminum
3
extrusion
2. Guide fence
3. Spacer blocks
4. Horizontal vise
(optional
accessory)
4
Over 540mm (21-1/4")
20mm (13/16")
120mm 120mm 72mm
(4-3/4") (4-3/4") (2-13/16")
115mm-120mm
(4-1/2" - 4-3/4")
1