Operating The Electromagnetic Brakes - Vermeiren Express VB Manual De Instrucciones

2.13 Operating the electromagnetic brakes

Let go of the joystick to stop the electric wheelchair.
2.13.1 Parking the electric wheelchair
Once your electric wheelchair has been turned off, no command can be sent to the driving
system. Always park your electric wheelchair on sites that are easy accessible and on
horizontal surfaces that the four wheels are touching the ground.
2.13.2 Operator units
The instructions for use from the operator units you can find in the seperate user manals of
the operator units that is included with your wheelchair.
Changing the software is only allowed by Vermeiren. For changes in the software
contact Vermeiren.
2.13.3 Adjusting operator unit
L
CAUTION:
Risk of pinching - Do not put your fingers between the operator
control and the other parts when positioning the operator unit.
The operator unit's horizontal position can be changed:
1. Loosen screw  just under the armrest a little bit.
2. Move the operator unit to the desired position or remove the operator unit.
3. Retighten screw  properly.
If you pull screw  to the side, the operator unit can be turned to the side.
NOTE: Depending on the features of your wheelchair, screw  could also be located
beneath the guide tube ➁ .
1
2
2.13.4 Connections for charger / program unit
L
WARNING:
Risk of injury - Check that all plugs (battery charger and
programming unit) are removed before setting the wheelchair in motion.
The socket  for connecting the charger supplied is
located on the front of the operator unit. Here, too, is the
connnection for the programming unit, which should only
be connected and used by authorised persons who have
been trained to program it (Vermeiren personnel).
Make sure that the joystick is in the neutral (central)
position when pressing the on/off button, otherwise
the electronics will be blocked. This block can be
lifted by switching the control unit off and then on
again.
Page 15
Express VB
2016-08