Toto CST243EF Manual De Instrucciones página 6

5) Flush the water supply line for a few seconds
to remove any debris that may enter the
new fill valve. (For new home constructions
and/or additions, flush the water supply line
for more than a minute to help remove any
residual PVC adhesives, solder flux, and/ or
pipe sealants that were used for the new
plumbing.) Connect the water supply line to
the fill valve threads as seen at the bottom
of toilet tank (see Illustration 7). Tighten this
connection finger tight.
CAUTION: Avoid using a wrench to tighten
the connection as you may damage the
plastic threads and/or cause the fill valve to
rotate inside the tank.
NOTE: The water supply pressure should be
20 to 80 psi static.
6) No ballcock / fill valve adjustments are
needed. The water will automatically stop at
proper level. Flush the toilet several times.
Check flapper valve for proper operation.
Make sure that chain is not tangled and that
the flapper arm is in its proper position.
7) Install the toilet tank lid onto the toilet tank
top.
8) Install the toilet seat onto the toilet bowl
using the mounting hardware in the toilet
seat box. Place seat onto bowl and rotate
the hinge down. Position seat stoppers
under the seat hinge. Insert bolt into seat
hinge and through the toilet bowl. Install
plastic nut onto bolt from underneath.
Tighten the bolt securely. Install the seat
bolt caps.
NOTE: Tighten the seat bolt until the hinge is
secure. The seat and lid will have slight side
to side movement, which is normal. This
freedom of movement allows the seat to
SoftClose® without binding.
INSTALLATION PROCEDURE
6
Ill. 7
7/8" Ballcock Th read
HAND TIGHTEN ON
Ill. 8
Seat
Hinge
MOUNTING HARDWARE
1
4
5
1 - Cap
2 - Plastic Bolt
3 - Seat Hinge
4 - Seat Stopper
5 - Toilet Bowl
6 - Plastic Nut
LY
Cap
Plastic
Bolt
Seat
Stopper
Bowl
Plastic Nut
3
2
6