Software Version; System Reset - Sangean DPR69+ Manual De Instrucciones

Software version

The software display cannot be altered and is just for your reference.
Ensure your radio is switched on and in DAB mode.
1. To view the software version on the display press and hold the
Info button for 2 seconds.
2. Repeatedly press the Tuning Up/Down button until the display shows
"SW version" on the lower line. Press the Select button to enter the
SW version. The version number is then shown on the lower line of
the display. Press and release the Info button to normal tuning mode.

System reset

If your radio fails to operate correctly, or some digits on the display are
missing or incomplete carry out the following procedure.
1. Press and hold down the Info button for 2 seconds
2. Repeatedly press the Tuning Up/Down buttons until the display
shows "Factory reset", then press the Select button.
3. If you wish to perform the reset operation, press the Select button
one more time. A full reset of your radio will be performed. All presets
and station lists will be erased.
4. After a system reset a scan of the DAB band will be performed.
In case of malfunction due to electrostatic discharge, reset the
product (reconnection of power source may be required) to resume
normal operation.
19