Cleaning Grease Filters; Installing Grease Filters; Cooktop/Night Light Replacement; Oven Light Replacement - Panasonic INVERTER NN-SD277SR Instrucciones De Operación E Instalación

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Care and Cleaning of Your Microwave Oven

Cleaning Grease Filters

The Grease Filters should be removed and cleaned often, at
least once a month.
1. Grasp the "metal ring" on the Grease Filter. Slide the
Grease Filter to the rear of oven.
2. Pull the Grease Filter out.
3. Use care when cleaning the Grease Filters. Corrosive clean-
ing agents, such as lye-based oven cleaners, may damage
the Grease Filters. Clean the Grease Filters with a warm
detergent solution. Do not use ammonia or other alkaline
solutions because it will darken metal. Light brushing can be
used to remove embedded dirt. Shake and remove moisture
before replacing.

Installing Grease Filters

1. Slide in the edge of the Grease Filters along the opening's
guide edges.
guide
2. Push up front edge and pull forward until it fits.
Caution: After removing the Grease Filter, be careful of any
sharp edges at the openings.
Never operate the Vent Fan without the Grease Filters in
place.

Cooktop/Night Light Replacement

Be careful as the Cooktop Light Cover and the bulb may be
hot.
1. Unplug microwave oven or disconnect power.
2. Loosen the screw to open the Cooktop Light Cover.
(Be careful not to lose the screw.)
screw
Cooktop Light Cover
3. Replace the old bulb with a new one.
(use 115-125 V, 30 W bulb)
If this bulb is not available locally, contact your local
Panasonic dealer. Part number is F60305H00AP.
4. Reinstall the Cooktop Light Cover with a screw.
Grasp the ring
opening
Grease Filter

Oven Light Replacement

Be careful as the Oven Light Cover and the bulb may be
hot.
1. Unplug microwave oven or disconnect power.
2. Remove the Vent Grille and Charcoal Filter.
(see page 25 for Charcoal Filter replacement).
3. Lift the tab of Oven Light Cover, and push back. Lift up and
remove the cover.
4. Replace the old bulb with a new one.
(use 115-125 V, 30 W bulb)
If this bulb is not available locally, contact your local
Panasonic dealer. Part number is F60305H00AP.
5. Reinstall the Oven Light cover securely aligning the hole in
cover, onto the detent.
When cleaning the Oven Light Cover or the adjacent area,
clean with a soft damp cloth.
To avoid scratches, do not use harsh detergents or abrasives.
26
(continued)
Oven Light Cover
hole
detent

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Inverter nn-sd277brInverter nn-sd277wr

Tabla de contenido