Wheeled Carriage - Textron Greenlee Ultra Tugger 15000-22 Manual De Instrucciones

Setup (cont'd)

Wheeled Carriage

Requires: Adequate clearance. See "Typical Setups
Illustrated."
1. Mount the boom mount to the wheeled carriage.
Align the boom mount holes with the top holes in the
wheeled carriage, as illustrated. Install a pin through
the boom mount and wheeled carriage. Secure the
pin with a hitch pin clip.
2. Position the puller's gearbox above the boom mount
cradle. Align the puller so that the puller mounting
plates straddle the boom mount plates. Lower the
puller onto the boom mount. Install two pins from the
motor side. Secure the pins with two hitch pin clips.
Greenlee / A Textron Company
®
Ultra Tugger Cable Puller and Pulling Packages
3. Check the right angle sheave support tube to be
4. Rotate the puller and boom mount as shown. When
33
sure it is fastened with the pin.
Removable Pin
the second hole in the boom mount is aligned with
the second hole in the wheeled carriage, install a
pin. Secure the pin with a hitch pin clip.
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070