Table Of Conductors And Circuit Breakers - Kripsol KS Serie Manual De Instrucciones

SYMPTOM
2.MECHANICAL
2.1 Obstructed flow.
2.2 The pump doesn't prime.
2.3 Internal leaks.
Missing parts.
2.4
3.INSTALLATION
The pressure required for the
3.1
installation is higher than the
pump pressure.
3.2 Obstructionontheintake.
The pump pressure is higher than
3.3
the installation pressure for the
defined flow.
The intake height exceeds 3 m.
3.4

10. TABLE OF CONDUCTORS AND CIRCUIT BREAKERS

●
This table applies to both 50Hz y 60Hz
MOTOR
FREQUENCY
POWER
0,33 HP 50/60 Hz
0,50 HP
50/60 Hz
0,75 HP
50/60 Hz
1,00 HP
50/60 Hz
1,50 HP 50/60 Hz
2,00 HP
50/60 Hz
3,00 HP 50/60 Hz
Locate and remove the obstruction. See the corresponding section
of this manual for instructions on how to disassemble the pump.
Try to prime the pump again. Check the intake system for air leaks.
Check the impellor for wear on the seals.
See repair instructions.
Inspect and repair.
Compare the pressure and flow of the pump on the pump curve.
Check that the valve on the discharge is not partially or fully closed.
Reduce the pressure requirements of the installation.
Locate and remove the obstruction.
Check the intake pipe for obstructions, leaks, open by-pass valves, etc.
If necessary, reduce the flow by partially closing the discharge valve.
Install the pump as close as possible on the vertical line of the
intake tank.
SINGLE-PHASE /
VOLTAGE
THREE-PHASE
230 V SINGLE-PHASE
230 V SINGLE-PHASE
230 V
THREE-PHASE
400 V
230 V
SINGLE-PHASE
230 V
THREE-PHASE
400 V
230 V
SINGLE-PHASE
230 V
THREE-PHASE
400 V
230 V SINGLE-PHASE
230 V
THREE-PHASE
400 V
230 V SINGLE-PHASE
230 V
THREE-PHASE
400 V
SINGLE-PHASE
230 V
230 V
THREE-PHASE
400 V
32
POSSIBLE CAUSE
CIRCUIT
BREAKER
RANGE
1.6 - 2.5 A
2.5 - 4 A
1.6 - 2.5 A
1.0 - 1.6 A
2.5 - 4 A
2.5 - 4 A
1.6 - 2.5 A
4 - 6.3 A
2.5 - 4 A
1.6 - 2.5 A
6.3 - 10 A
4 - 6.3 A
2.5 - 4 A
6.3 - 10 A
4 - 6.3 A
2.5 - 4 A
10 - 16 A
6.3 - 10 A
4 - 6.3 A
CABLE SECTION