HIKOKI G 3614DA Instrucciones De Manejo página 11

NAMES OF PARTS (Fig. 1 – Fig. 15)
Motor
Nameplate
Lock pin
Side handle
Gear cover
Depressed center
wheel
M5 hex. socket bolt
Wheel guard
Switch knob
Dial
Filter
Battery
Switch lever
Latch
SYMBOLS
WARNING
The following show symbols used for the machine.
Be sure that you understand their meaning before
use.
G3613DA / G3613DB: Cordless Disc Grinder
To reduce the risk of injury, user must read
instruction manual.
Always wear eye protection.
Only for EU countries
Do not dispose of electric tools together with
household waste material!
In observance of European Directive 2002/96/EC
on waste electrical and electronic equipment and
its implementation in accordance with national law,
electric tools that have reached the end of their life
must be collected separately and returned to an
environmentally compatible recycling facility.
V Rated voltage
n
Rated speed
n
No-load rotation speed
0
min Revolution or reciprocations per minute
-1
Switching ON
Switching OFF
Disconnect the battery
Charge indicator lamp
Battery level indicator
switch
Battery level indicator
lamp
Lever
Hex. bar wrench
Wheel washer (C)
Wheel nut
Wrench
With side guard
Abrasive cutting
wheel
Off -lock lever
Rubber cover
USB port
USB cable
11
Warning
Remaining battery indicator switch
Battery
Lights ;
The battery remaining power is over 75%
Lights ;
The battery remaining power is 50% – 75%.
Lights ;
The battery remaining power is 25% – 50%.
Lights ;
The battery remaining power is less than 25%
Blinks ;
The battery remaining power is nearly empty.
Recharge the battery soonest possible.
Blinks ;
Output suspended due to high temperature.
Remove the battery from the tool and allow it to
fully cool down.
Blinks ;
Output suspended due to failure or malfunction.
The problem may be the battery so please
contact your dealer.
STANDARD ACCESSORIES
In addition to the main unit (1 unit), the package contains the
accessories listed on page 273.
Standard accessories are subject to change without notice.
APPLICATIONS
○ Removal of casting fi n and fi nishing of various types of
steel, bronze and aluminum materials and castings.
○ Grinding of welded sections or sections cut by means of
a cutting torch.
○ Grinding of synthetic resins, slate, brick, marble, etc.
SPECIFICATIONS
1. Power tool
Model
G3613DA
Voltage
Rated speed
Outer dia.
Wheel Hole dia.
Thickness
Peripheral speed
Battery available
for this tool*
Weight**
* Existing batteries (BSL3660/3620/3626,
series, etc.) cannot be used with this tool.
** Weight: According to EPTA-Procedure 01/2003
English
G3613DB
36 V
Transmission mode:
3000 – 9500 min
-1
Auto mode:5500 min
-1
125 mm
22.23 mm
6 mm
80 m/s
BSL36A18
2.8 kg
BSL18xx