Torque Limiter - Makita DHR202 Manual De Instrucciones

Hammering only
1
007577
For chipping, scaling or demolition operations, depress
the lock button and rotate the action mode changing
knob to the symbol. Use a bull point, cold chisel,
scaling chisel, etc.
CAUTION:
Do not rotate the action mode changing knob when
•
the tool is running. The tool will be damaged.
To avoid rapid wear on the mode change
•
mechanism, be sure that the action mode changing
knob is always positively located in one of the three
action mode positions.

Torque limiter

The torque limiter will actuate when a certain torque level
is reached. The motor will disengage from the output
shaft. When this happens, the bit will stop turning.
CAUTION:
As soon as the torque limiter actuates, switch off
•
the tool immediately. This will help prevent
premature wear of the tool.
Hole saws cannot be used with this tool. They tend
•
to pinch or catch easily in the hole. This will cause
the torque limiter to actuate too frequently.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Side grip (auxiliary handle)
1
2
6
5
4
3
008830
1. Hammering only
1. Grip base
2. Teeth
3. Side grip
4. Protrusion
5. Loosen
6. Tighten
7
CAUTION:
Always use the side grip to ensure operating safety.
•
Install the side grip so that the teeth on the grip fit in
between the protrusions on the tool barrel. Then tighten
the grip by turning clockwise at the desired position. It
may be swung 360° so as to be secured at any position.
Bit grease
Coat the bit shank head beforehand with a small amount
of bit grease (about 0.5 -1 g; 0.02 - 0.04 oz.). This chuck
lubrication assures smooth action and longer service life.
Installing or removing the bit
Clean the bit shank and apply bit grease before installing
the bit.
1
2
001296
Insert the bit into the tool. Turn the bit and push it in until it
engages.
1
007342
If the bit cannot be pushed in, remove the bit. Pull the
chuck cover down a couple of times. Then insert the bit
again. Turn the bit and push it in until it engages.
After installing, always make sure that the bit is securely
held in place by trying to pull it out.
To remove the bit, pull the chuck cover down all the way
and pull the bit out.
1
001298
1. Bit shank
2. Bit grease
1. Bit
2. Chuck cover
2
1. Bit
2. Chuck cover
2