DeWalt DWE560 Manual De Instrucciones página 45

ADJUSTING DEPTH ADJUSTMENT LEVER (FIG. 6)
It may be desirable to adjust the depth adjustment lever (P). It may
loosen in time and hit the foot plate before tighten ing.
To tighten the lever, follow the steps below.
1. Hold depth adjustment lever (P) and loosen the locknut (S).
2. Adjust the depth adjustment lever by rotating it in the desired
direction about 1/8 of a revolution.
3. Retighten nut.
Bevel Angle Adjustment (Fig. 8)
WARNING: To reduce the risk of injury, turn unit off and
disconnect it from power source before installing and removing
accessories, before adjusting or when making repairs. An
accidental start-up can cause injury.
On the front of the saw is a
FIG. 8
bevel angle adjustment
mechanism (G) which consists
LOOSEN
of an angle quadrant with a
pointer and a bevel adjustment
knob (F). The angle quadrant
allows for coarse adjustment.
To achieve better accuracy in
cutting, use the fine
adjustment markings located
on the pivot bracket (U). The
full range of bevel adjustment
is 0 to 48°. The pivot bracket
is graduated in increments
of 1°.
1. To set the saw for a bevel cut, turn the bevel adjustment knob (F)
to loosen the bevel adjustment.
2. Tilt the foot plate to the desired angle by aligning the pointer with
the desired angle mark on the pivot bracket (U).
3. Retighten the bevel adjustment by turning the knob.
TIGHTEN
F
G
Adjustable Cord Protector (Fig. 9–11)
The adjustable cord protector (V) allows the cord to be positioned
vertical or parallel to the blade. It is shipped in the vertical position.
FIG. 9
V
PARALLEL
TO OBTAIN THE PARALLEL POSITION (FIG. 10)
1. Press the cord protector (V) in as indicated by the arrow.
2. Rotate the cord protector clockwise to the parallel position.
FIG. 10
U V
TO OBTAIN THE VERICAL POSITION (FIG. 11)
1. Press the cord protector (V) in as indicated by the arrow.
2. Rotate the cord protector counterclockwise to the vertical
position.
43
V
VERTICAL
V