Stihl MS 382 Manual De Instrucciones página 78

English
When engine begins to fire
1
Set the Master Control lever (1) to
N
the starting throttle position (n).
Press the button to open the
N
decompression valve.
Hold and start your saw as
N
described.
As soon as the engine runs
1
2
Blip the throttle trigger (2), the
N
Master Control lever (1) moves to
the run position (F) and the engine
settles down to idling speed.
76
0
Pull the hand guard back towards
N
the front handle.
The chain brake is now disengaged –
your saw is ready for operation.
NOTICE
Always disengage chain brake before
accelerating the engine. High revs with
the chain brake engaged (chain locked)
will quickly damage the clutch and chain
brake.
At very low outside temperatures
Allow engine to warm up at part
N
0
throttle.
Stopping the Engine
Move the Master Control lever to the
N
stop position (0).
If the engine does not start
Check that all settings are correct.
N
Check that there is fuel in the tank
N
and refuel if necessary.
Check that the spark plug boot is
N
properly connected.
Repeat the starting procedure.
N
or:
It is possible that the fuel-air mixture in
the combustion chamber is over-rich
and has flooded the engine.
Remove the spark plug – see
N
"Spark Plug".
Dry the spark plug.
N
Move the Master Control lever to the
N
stop position (0).
Crank the engine several times with
N
the starter to clear the combustion
chamber.
Install the spark plug – see "Spark
N
Plug".
Set Master Control lever to n –
N
even if the engine is cold.
Now start the engine.
N
MS 382