Dymo LabelWriter 4XL Guía Rápida De Inicio página 8

3. Connecting your LabelWriter Printer
Do not connect the printer to your computer until after the
NOTE
software installation is complete.
To connect the power
Plug the power cord into the power adapter. See Figure 3.
1
Plug the power adapter into the power connector on the bottom of
2
the printer. See Figure 4.
Plug the other end of the power cord into a power outlet.
3
Plug the USB cable into the USB port on the bottom of
4
the printer.
Insert the power and USB cables through the cable
5
channel and set the printer down.
When the software is completely installed, connect the
6
other end of the USB cable into an available USB port on
your computer.
If the printer is not in the printer list when the installation is complete, refer to the
Mac OS
ReadMe file for instructions on how to add the printer.
4
Power adapter
Power cord
Figure 3
USB
USB 24VDC
Cable
channel
Figure 4
Power