Makita DTW253 Manual De Instrucciones página 6

Lighting up the front lamp
1
► 1. Lamp
CAUTION:
• Do not look in the light or see the source of light
directly.
Pull the switch trigger to light up the lamp. The lamp
keeps on lighting while the switch trigger is being pulled.
The light automatically goes out 10 - 15 seconds after
the switch trigger is released.
NOTE:
• Use a dry cloth to wipe the dirt off the lens of
lamp. Be careful not to scratch the lens of lamp,
or it may lower the illumination.
Reversing switch action
A
► 1. Reversing switch lever
This tool has a reversing switch to change the direction
of rotation. Depress the reversing switch lever from the
A side for clockwise rotation or from the B side for coun-
terclockwise rotation.
When the reversing switch lever is in the neutral posi-
tion, the switch trigger cannot be pulled.
CAUTION:
• Always check the direction of rotation before operation.
• Use the reversing switch only after the tool comes
to a complete stop. Changing the direction of
rotation before the tool stops may damage the tool.
• When not operating the tool, always set the
reversing switch lever to the neutral position.
B
1
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
the battery cartridge is removed before carrying
out any work on the tool.
Selecting correct socket
Always use the correct size socket for bolts and nuts. An
incorrect size socket will result in inaccurate and inconsis-
tent fastening torque and/or damage to the bolt or nut.
Installing or removing socket
1
2
► 1. Socket 2. Anvil
To install the socket, push it onto the anvil of the tool
until it locks into place.
To remove the socket, simply pull it off.
OPERATION
CAUTION:
• Always insert the battery cartridge all the way until
it locks in place. If you can see the red indicator on
the upper side of the button, it is not locked com-
pletely. Insert it fully until the red indicator cannot
be seen. If not, it may accidentally fall out of the
tool, causing injury to you or someone around you.
Hold the tool firmly and place the socket over the bolt or nut.
Turn the tool on and fasten for the proper fastening time.
6 ENGLISH