Husqvarna R 318X Manual De Usuario página 15

• Do a check of the fuel level before each use and
refuel if it is necessary.
• Do not fully fill the fuel tank. Keep a space of a
minimum 2.5 cm.
To adjust the seat
WARNING:
during operation of the product.
1. To adjust the seat forward and rearward, put your
feet on the footrest plates.
2. Push the lever below the front edge of the seat up
and move the seat to the correct position.
To adjust height of the steering wheel
WARNING:
the steering wheel during operation of the
product.
1. Turn the knob counterclockwise to loosen.
2. Adjust the height of the steering wheel.
3. Turn the knob clockwise to tighten.
CAUTION:
of the knob points up.
838 - 007 - 03.11.2021
Do not adjust the seat
Do not adjust the height of
Make sure that the long end
To engage and disengage the drive
system
To move the product with the engine off, the drive
system must be disengaged. Pull out the drive system
lever fully to disengage the drive on the axle. Push the
drive system lever in fully to engage the drive on the
axle. Do not use middle positions.
The drive system lever for model R 318X is found
behind the left rear wheel. Model R 320X AWD has one
drive system lever for the front and one for the rear axle.
The drive system lever for the rear axle is found behind
the left rear wheel.
The drive system lever for the front axle for R 320X
AWD is found behind the left front wheel.
To lift and lower the cutting deck
To lift the cutting deck to transport position, pull the lift
lever rearward. If the engine is on, the blades stop to
rotate automatically.
15