Husqvarna R 318X Manual De Usuario página 33

2. Make sure that the center of gravity of the product is
above the wheel axle of the transport vehicle. If a
trailer is used for transport, make sure that the down
force on your tow bar is correct.
3. Apply the parking brake.
4. If the product has Bluetooth
Husqvarna Connect.
5. Lower the cutting deck to the mow position.
6. Remove all loose objects.
7. Assemble the first strap through the rear
transmission frame. Refer to the illustration.
8. Tighten the strap rearward to attach the product to
the load area.
9. Put the second strap around the frame tunnel.
10. Attach the strap to the load area.
11. Tighten the strap in the direction of the front of the
load area to attach the product to the load area.
838 - 007 - 03.11.2021
®
, lock the product with
12. Put the wheel blocks in front of and behind the rear
wheels.
To tow the product
The product has a hydrostatic transmission. To prevent
damage to the transmission, tow the product short
distances only and at low speed.
Disengage the transmission before you tow the product.
To engage and disengage the drive system on
Refer to
page 15 .
Storage
Prepare the product for storage at the end of the
season, and before more than 30 days of storage. If you
keep fuel in the fuel tank for 30 days or more, tacky
particles can cause blockage in the carburetor. This has
a negative effect on the engine function.
To prevent tacky particles during storage, add a
stabilizer. If alkylate gasoline is used, stabilizer is not
necessary. If you use standard gasoline, do not change
to alkylate gasoline. This can cause sensitive rubber
parts to become hard. Add stabilizer to the fuel in the
tank or in the container used for storage. Always use the
mixing ratios given by the manufacturer. Run the engine
for a minimum of 10 minutes after you add the stabilizer
until it flows into the carburetor.
WARNING:
with fuel in the tank in an indoor location or
in locations with bad airflow. Risk of fire if
fuel fumes come near open flames, sparks,
or pilot lights in for example boilers, hot
water tanks and clothes dryers.
WARNING:
other flammable materials from the product
to decrease the risk of fire. Let the product
become cool before you put it in storage.
• Clean the product, see
20 . Repair paint damages to prevent corrosion.
• Examine the product for worn or damaged parts and
tighten loose screws and nuts.
• Remove the battery. Clean it, charge it, and keep it
cool during storage.
Do not keep the product
Remove grass, leaves and
To clean the product on page
33