Bosch GST 120 E Professional Manual Original página 24

OBJ_BUCH-615-001.book Page 24 Wednesday, January 16, 2008 1:23 PM
24 | English
Changing the Pre-tension of the Base Plate
With the thumbwheel 21, the pre-tension of the
base plate clamping lever 22 can be changed.
When the base plate 9 is not seated tightly after
closing the lever, open the clamping lever and
turn the thumbwheel for pre-tension of the base
plate in the "+" direction.
When the base plate cannot be adjusted or only
with difficulty after opening the clamping lever,
turn the thumbwheel in the " – " direction.
Sawdust Blower Device
With the air jet of the sawdust blower device 10,
the cutting line can be kept free of dust and
chips.
Switching on the sawdust blower device: For
cuts in materials with high removal rate, such as
in wood, plastic, etc., push the switch 10 to po-
sition "I".
Switching off the sawdust blower device: For
cuts in metal and when a dust extraction system
is connected, push the switch 10 to position "0".
Starting Operation
Observe correct mains voltage! The voltage
of the power source must agree with the
voltage specified on the nameplate of the
machine. Power tools marked with 230 V
can also be operated with 220 V.
Switching On and Off (GST 120 E)
To start the machine, push the On/Off switch 3
forwards.
To switch off the machine, push the On/Off
switch 3 toward the rear so that the "0" is indi-
cated on the switch.
Switching On and Off (GST 120 BE)
To start the machine, press the On/Off switch 3.
To lock the On/Off switch 3, keep it depressed
and push the lock-on button 2 to the right or left.
To switch off the machine, release the On/Off
switch 3. When the On/Off switch 3 is locked,
press it first and then release it.
1 609 929 N44 | (16.1.08)
Controling the Stroke Rate (GST 120 BE)
Increasing or reducing the pressure on the
On/Off switch 3 enables stepless stroke-rate
control of the switched-on machine.
Light pressure on the On/Off switch 3 results in
a low stroke rate. Increasing the pressure also
increases the stroke rate.
When the On/Off switch 3 is locked, it is not
possible to reduce the stroke rate.
Presetting the Stroke Rate
With the thumbwheel for stroke rate preselec-
tion 5, the stroke rate can be preset and
changed during operation.
1 – 2:
Low stroke rate
3 – 4:
Medium stroke rate
5 – 6:
High stroke rate
The required stroke rate is dependent on the
material and the working conditions and can be
determined by a practical trial.
Reducing the stroke rate is recommended when
the saw blade engages in the material as well as
when sawing plastic and aluminium.
After longer periods of work at low stroke rate,
the machine can heat up considerably. Remove
the saw blade from the machine and allow the
machine to cool down by running it for approx.
3 minutes at maximum stroke rate.
Working Advice
When working small or thin work pieces, al-
ways use a sturdy support or a saw table
(accessory).
While working, hold the machine by the handle
4 and guide it alongside the desired cutting line.
For precise cuts and quiet running, guide the
machine additionally with the other hand by the
plastic cap 1.
Contact Protector
The contact protector 15 attached to the casing
prevents accidental touching of the saw blade
during the working procedure and may not be
removed.
Bosch Power Tools