Maintenance And Cleaning - T-Fal ULTRAGLIDE DIFFUSION FV32 Serie Manual Del Usuario

NOT FV32XX FTC 036635
• Set the temperature control dial to
• Repeatedly press the
continuously move the iron over the fabric (
• Hold the iron a few inches from the fabric to avoid burning delicate
fabrics.
When the auto-off warning
light is on, it is normal for the
temperature light to remain off.
Storing your iron
• Set the steam control lever to
• Let the soleplate cool completely and empty the water tank. A small
amount of water may remain in the water tank.
• Wrap the cord around the heel of the iron.
• Store the iron on its heel (

Maintenance and cleaning

Cleaning the anti-scale valve
It is recommended that you clean the anti-scale valve once a month to
remove scale build up on the valve.
Clean the anti-scale valve as noted below:
• Unplug your iron and empty the water tank.
Self-Clean
• Press the
fig.12b
scale valve (
• Soak the valve (the black section only) in white vinegar or plain lemon
juice for 4 hours.
• Rinse the valve under running water and put the anti-scale valve back.
5/12/06 11:39 Page 5
fig.4
MAX
(
Burst of Steam
button
fig.9
3-Way automatic shut-off
The iron is equipped with an electronic system that will automatically cut
the power source to your iron if it is left vertically on its heel for more than
8 minutes, on its soleplate for more than 30 seconds or on its side for more
than 30 seconds.
The auto-off warning light (
off mode.
• To restart the iron, gently shake the iron until the warning light stops
flashing.
and unplug the iron.
fig.11
).
fig.12a
ejection button (
)
It is recommended that you clean the iron once a month to slow down
scale build up and prolong the life of the iron.
Clean your iron as noted below:
• Unplug the iron, set the steam control lever to
tank to MAX.
• Place the iron on its heel, set the temperature dial to MAX, plug in the
iron and wait for the indicator light to go out.
• Unplug the iron and place it horizontally over a sink.
Self-Clean
• Press the
scale valve (
• Gently shake the iron over the sink until all of the water (along with
impurities) runs out through the soleplate.
• At the end of the operation, put the anti-scale valve back into the iron
and allow it to heat for 2 minutes on its heel to dry the soleplate.
).
fig.7
( ) and
).
fig.10
) will flash when the iron is in the shut
Unplug your iron and let it cool
completely before cleaning it.
The iron will not function with-
out the anti-scale valve.
Never touch the end of the
) and remove the anti-
valve !
ejection button (
fig.12b
).
The steam is very hot.
When using the vertical steam
function, always iron with the
garment on a hanger, never
while wearing it.
(depending on model)
Cleaning the iron
and fill the water
fig.12a
) and remove the anti-
ENG
5