Assembly - Attaching the Light Kit
8
Installing the light kit pan
IMPORTANT: It is critical to attach the light kit pan
using quick connector. The fan will not operate unless
the light kit pan is connected to the fan.
□
Remove one screw (OO) from the black bracket below the fan
motor assembly (C), and loosen but do not remove the other two
screws.
□
Connect the 9-pin plug exiting the bottom of the fan motor
assembly (C) to the 9-pin plug from the light kit pan (F). Be sure
the plug connections snap together completely.
□
Push the light kit pan (F) up to the fan motor assembly (C) so that
the two loosened screw heads fit into the keyhole slots. Turn the
light kit pan (F) clockwise.
□
Re-install the screw (OO) that was removed in step 1.
□
Make sure all the screws are firmly tightened.
9
Attaching the light kit fitter assembly
CAUTION: To reduce the risk of electric shock, disconnect
the electrical supply circuit to the fan before installing the
light kit.
□
Remove one screw (PP) from the light kit pan (F) and loosen
but do not remove the other two screws.
□
Connect the wires from the light kit fitter assembly (E) to the
wires from the light kit pan (F) by connecting the molded
adaptor plugs together. Carefully tuck all wires and splices into
the switch cup.
□
Push the light kit fitter assembly (E) up to the light kit pan
(F) so that the two loosened screw heads fit into the keyhole
slots. Turn the light kit fitter assembly (E) clockwise.
□
Re-install the screw (PP) that was removed in step 1.
□
Make sure all the screws are firmly tightened.
10
□
Place the glass bowl (G) into the light kit pan (F), aligning the
three flat areas on the top flange of the glass bowl (G) with the
raised dimples in the light kit pan.
□
Turn the glass bowl (G) clockwise until it stops.
F
E
PP
10
C
F
OO
Installing the glass bowl
WARNING: Allow the glass bowl to cool completely before
removing.
CAUTION: Make sure the power is off before attaching or
removing the glass bowl.
F
G