Installation And Height Adjustment - Permobil ROHO AGILITY CARBON Manual Del Usuario

Installation and Height Adjustment

Warnings:
- DO NOT install, remove, or adjust the height of the product while the individual is
seated in the wheelchair.
- After you install the product, and before the individual transfers into the
wheelchair, make sure that all hardware is securely tightened. Refer to the
recommended torque specifications.
Note: The AGILITY CARBON can be used in a flipped position. Refer to "Flip the
Back Shell" instructions in this manual.
Installation Option A
Use this option if the wheelchair canes do not have push handles or other equipment that may interfere with installation.
1. Before installing the product make sure the hardware
is correct for the wheelchair and back shell. See
"Hardware Selection".
2. Loosen, but do not remove, the cane clamp screw.
Repeat for the other side.
Note: If the outer cane clamp becomes detached, see
Installation Option B, step 5.
3. Slide the cane clamps onto the canes to the desired
height.
Note: If the product does not fit properly on the
wheelchair, repeat "Hardware Selection".
4. Tighten the cane clamp screws until snug + one-
quarter turn.
Note: If a torque wrench is available, tighten to no
more than 40 inch-pounds (4.5 Newton-meters).
5. Use a tape measure to make sure the cane clamps
are at the same height.
6. If needed, adjust the height and re-tighten the
hardware (see the previous steps).
Warning: Have the individual safely transfer into
the wheelchair.
PSIS Warning: Make sure that the product is
positioned so that the bottom portion makes contact with
the Posterior Superior Iliac Spine (PSIS). If the product is
NOT positioned to make contact with the PSIS, pelvic
support and trunk control may be reduced.
ROHO AGILITY CARBON Contour Back Support Operation Manual
9
Follow the instructions for Installation Option A or Installation Option B,
depending on the wheelchair cane type.
Option A
PSIS
Option B
The 1 in. (2.5 cm) outer
cane clamp is shown.
PSIS