Descargar Imprimir esta página

EWT PF120 TLSW Manual De Instrucciones página 4

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 8
Dear Customer,
Please read the following information carefully before using
the appliance for the first time for your own safety and to
ensure correct use.
Attention! The appliance may only be used for normal domestic
use and not for industrial purposes.
Important safety advice
The appliance must only be used as described in the
instructions for use! Use for any other purpose is forbidden! Any
damage resulting from improper use and non-observance of the
safety information will invalidate any liability and warranty!
All liability is disclaimed for any frost damage caused by a
heating capacity that is insufficient for the room size, bad
heat insulation of the room, incorrect use or force majeure
(e.g. power failure).
Only connect the appliance to A.C. mains as specified on
the rating plate!
Never touch live parts!
Danger to life!
Never operate the appliance with wet hands!
The appliance must be placed in a way that the control elements
cannot be touched by persons who are in bath, shower, or any
other water-filled receptacle.
Do not use the appliance in rooms with bath, shower or
swimming pool or in the vicinity of wash basins or water
connections!
Do not expose the appliance to rain or other moisture! The
appliance is nor for outdoor use. The appliance must only be
stored indoors!
Never use the appliance if the appliance or cord is damaged.
Risk of injury!
Check the power cord regularly for damage.
If the power cord or if the appliance is damaged to the extent
that electrical parts are exposed, disconnect it immediately
from the mains and see your authorised retailer!
Improper repairs can expose the user to considerable
danger.
The appliance may only be opened up and repaired by
authorised qualified personnel.
Do not store or use any flammable materials or sprays in
the vicinity of the appliance when the appliance is in use.
Fire hazard!
Do not use the appliance in flammable atmospheres (e.g. in
the vicinity of combustible gases or spray cans)! Explosion
and fire hazard!!
The appliance should not be used in areas which are a fire risk,
such as garages, stables, or wooden sheds.
Important!
Do not insert any foreign objects into the appliance
openings! Risk of injury (electric shock) and damage to the
appliance!
The appliance air inlet and outlet openings must not be
obstructed in any way!
Place the appliance so that it cannot be touched by accident.
Risk of burns!
WARNING: IN ORDER TO AVOID OVERHEATING,
DO NOT COVER THE HEATER.
The heater carries the Warning symbol indicating
that it must not be covered.
The appliance is not suitable for connection to permanent
wiring!
The appliance is not intended for use by young children or
infirm persons without supervision!
Young children should be supervised to ensure that they do
not play with the appliance!
The socket-outlet must be accessible at all times to enable the
mains plug to be disconnected as quickly as possible!
Attention!
To avoid any danger due to unintentionally resetting
the thermal cut-out, the appliance must not be supplied via
a timer.
The appliance is not suitable for animal breeding purposes!
The instruction leaflet belongs to the appliance and must be
kept in a safe place. When changing owners, the leaflet must
be surrendered to the new owner!
Packaging
After unpacking the appliance, check the same for transport
damage and the contents for completeness! In the event of
damage or an incomplete delivery, contact your authorised
retailer!
Do not discard the original box! It can be used for storage and
dispatch to avoid transport damage!
Dispose of the packaging material in a proper manner! Plastic
bags should be kept away from children!
Location
The appliance should be placed with a minimum distance of
50cm from flammable objects, walls or other structures! The
appliance openings must not be obstructed in any way!
Do not place the appliance on instable surfaces (e.g. a bed),
where it can tip over!
The appliance must not be located below a socket outlet!
The appliance must not be operated directly on high pile
carpets.
The appliance can be tilted to adjust the required blow out
direction at the base.
Power cord
Only use an approved extension cord that is suitable for the
appliance rating!
Position the power cord so that it does not pose a tripping
hazard and possibly cause the appliance to be knocked
over.
The power cord must not come into contact with hot appliance
parts!
Never pull the plug out of the socket at the cord!
Never move the appliance by pulling at the cord or use the
cord for carrying purposes!
Do not coil the cord around the appliance! Do not use the
appliance with the cord coiled! This applies particularly if a
cable drum is used.
Do not crush the cord or drag it over sharp edges. Do not place
it over heated hotplates or naked flames!
Start up
After switching on the appliance for the first time and after
Danger to life!
an extended period of non-use, a smell may be noticed for
a short time.
To use, insert the plug in the socket.
Switch (S) (see fig. 2)
With the selector, the fan can be switched on or the power setting
selected. There are four selection options: '
/ ' ' – 1200W / ' ' – 2000W
Thermostat (T) (see fig. 2)
In order to maintain a certain room temperature, set the controller
to "max.". Operate the appliance at full power until the required
room temperature is reached. Set back the thermostatic controller
until the appliance switches off with an audible "click". This
temperature will be kept almost constant by the thermostatic
control switching on and off automatically.
Please note that the appliance can only be switched on when the
thermostat setting is higher then the room temperature.
Attention! The unit is ready for use even when at the lowest
setting '
'.
In order to switch off the appliance, pull out the power supply
plug.
At any time while programming the timer you can press the
'PROGRAM' button to exit to the default display.
Note: If the 'ON' time is the same as the 'OFF' time the appliance
will ignore the program.
Transport (see fig. 4)
The appliance is provided with a handle for easy carrying
Frost protection (see fig. 2)
Set the thermostat to '
heating output.
When the temperature falls below +5 °C...+8 °C, the appliance
switches on automatically.
Overheat cut-out
The built-in overheat cut-out switches off the appliance
automatically in the event of a fault! Switch off the appliance (set
switch to '
' and thermostat to '
from the socket. After a short cooling down phase, the appliance
is ready for use again! If the fault should occur again, see your
local dealer!
- 1 -
' – Off / ' ' – 800W
' and the switch to the required the
') or disconnect the mains plug
Cleaning
Switch off the appliance first and disconnect the plug from
the socket!
Clean the housing with a moist cloth, vacuum cleaner or
brush.
Do not use any abrasive or caustic cleaning agents!
Do not use any flammable cleaning agents e.g. petrol or spirit
for cleaning the appliance.
Never immerse the appliance in water! Danger to life!
Air inlet- and outlet area should be cleaned with a vacuum
cleaner regularly
If the appliance is not used for extended periods, it must be
protected against excessive dust and dirt.
Recycling
For electrical products sold within the European
Community.
At the end of the electrical products useful life it
should not be disposed of with household waste.
Please recycle where facilities exist. Check with
your Local Authority or retailer for recycling advice
in your country.
After sales service
All repairs must be referred to authorised personnel!
See your local dealer.
Any tampering with the appliance will invalidate the warranty.
Repairs carried out improperly and by unqualified persons may
have serious consequences for the user!
In the interests of further development, the appliance may
be subject to constructional or design changes without
prior notice.
UK

Publicidad

loading