BALDR B0340WST2H2R-V7 Manual Del Usuario página 13

Problem
No outdoor
sensor reception
Inaccurate
temperature/
humidity
"HH.H/LL.L" display
in indoor and/or
outdoor temperature
If your BALDR product does not operate properly after trying the
troubleshooting steps, please contact the seller on your order
page or shoot an email to: service@baldr.com.
PLACEMENT INSTRUCTION
BALDR sensors are sensitive to surrounding environmental condi-
tions. Proper placement of both the main unit and outdoor sensor
are critical to the accuracy and performance of this product.
Possible Solution
1. Reload the batteries of both outdoor
sensor and main unit. Please refer to the
SENSOR SETUP section.
2. Relocate the main unit and/or the out-
door sensor. The units must be within
100m(328ft) of each other.
3. Make sure both units are placed at least
0.9 m (3 ft) away from electronics that may
interfere with the wireless communication
(such as TVs, microwaves, computers,
etc).
4. Use standard alkaline batteries. Do not
use heavy duty or rechargeable batteries.
NOTE: It may take a few minutes for
main unit and sensor to synchronize after
batteries are reloaded.
Make sure both the main unit and sensor
are placed out of direct sunlight and away
from any heat sources or vents.
If the temperature is higher than the detec-
tion range, "HH.H" will display on screen for
indication; if lower than the detection range,
"LL.L" will display on screen for indication.
13