Bulldog DC Serie Manual De Instrucciones página 16

1.8.2 Wireless Remote and Transmitter Installation
1. Connect The Wiring
Connect the Switch cord W/3 or 6 Pin
plugs to the socket on the control pack.
Connect the Red wire to the positive (+)
terminal of the battery.
Connect the Black wire to the negative (-)
terminal of the battery.
2. Mount the Receiver
The receiver should be mounted in a clear and
dry location.
Mount on a flat surface with at least 2 fasteners
(not included) through the 7 mm mounting holes
on each side of the receiver. Minimum of one
mounting fastener each side
1.8.3 Wireless Remote and Transmitter Installation
1. Install Battery
a. R emove the three screws from the wireless
transmitter.
b. S eparate the top section, insert the battery
positive (+) side up and replace the top
section.
c. Replace the three screws.
2. Test
a. Press the Power Button for 5 seconds until the Green light comes on.
b. Press the In/Down or Out/Up button. The Red indicator light will come on.
Power Button
Cable IN
16
CEQUENT
Installation Instructions
Figure 24 - Operations
LED Indicator
Cable OUT
PERFORMANCE PRODUCTS, INC. •
™
Figure 21 - Connections
Black
Figure 22 - Mounting
Figure 23 - Battery Replacement
Lithium Battery:
CR2032 (3V)
Cable IN
F3838-00 REV C (4782) 7/15
Fuse Red
Cable OUT