Measurement Procedure - Alcedo B21 Manual Del Usuario

Setting Month/Date:
Initial Month/Date is 1/01, when the Month display is flashing, press the MEM
button, the month will increase by 1, press SET button to confirm, and do in
the same way to set the date. Press SET button to confirm.
EN
Setting Time :
When the hour display is flashing, press the MEM button, the hour will
DE
increase by 1, press SET button to confirm, and do in the same way to set
the minute. Press SET button to confirm.
IT
Record Delete:
FR
When you checking the memory data, long press MEM button to delete
existing user measurement data.
ES
Note:
You can't delete all measurement record from the monitor storage at one
time, if you decide to delete the all record, please keep the record in another
way, in case you need it some days later. Take the battery out won't lead to a
record missing.
4.3. Cuff tube connection
Insert the cuff tube into the opening on the left side of the monitor （As
shown in picture-03)
10

5. Measurement Procedure

Note:
You should always be seated and calm before and during measurement.
5.1. Before measurement:
• Avoid eating and smoking as well as all forms of exertion directly before
measurement. These factors influence the measurement result. Find time to
relax by sitting in an armchair in a quiet atmosphere for about ten minutes
before taking a measurement.
• Remove any garment that fits closely to your upper arm.
• Always measure on the same arm (normally left).
• Always compare measurements taken at the same time of day, since blood
pressure changes during the course of the day, as much as 20-40 mmHg.
5.2. Common sources of error:
Note:
Comparable blood pressure measurements always require the same
conditions!
•Conditions should always be quiet.
•All efforts by the user to support the arm can increase blood pressure. Make
sure you are in a comfortable, relaxed position and do not flex any of the
muscles in the measurement arm during the measurement. Use a cushion for
support if necessary.
• If the arm artery lies considerably lower or higher than the heart, an
erroneously high or low blood pressure will be measured! Each 25-30cm
difference in height between your heart and the cuff results in a measurement
error of 10 mmHg!
• Cuffs that are too narrow or too short result in false measurement values.
Selecting the correct cuff is extremely important. Cuff size is dependent upon
the circumference of the arm (measured in the center). The permissible range
is printed on the cuff.
Cuff works Under the pressure range 0-300MMHG
The wide range rigid cuff is : 8.7" – 15.7" (22 - 40 cm)
Note: Only use approved cuffs!
• A loose cuff or a sideways protruding air pocket causes false measurement
values.
• With repeated measurements, blood accumulates in the arm, which can lead to
false results. Consecutive blood pressure measurements should be
repeated after a 1 minute pause or after your arm has been held up in order to
allow the accumulated blood to flow away. If you decide to take your Averaging
Mode measurement again, be sure to wait at least one minute beforehand.
EN
DE
IT
FR
ES
11