Tools Recommended For Installation; Using Quick-Connect Fittings - Watts Premier RO-PURE PLUS Manual De Instalación, Operación Y Mantenimiento

Tools Recommended for Installation

• 1¼" Diamond Tipped Hole Saw bit for
faucet opening (Counter Tops/Porcelain
& Stainless Sinks)
• Phillips bit for electric drill
• 1¼" Adjustable Wrench
• Adjustable Pliers
• Electric Drill
• Sharp Knife
• ⁄ " diamond tip bit, (pilot hole)
1
8
• Phillips Screw Driver
• ⁄ " Diamond tip bit (Drain saddle hole)
1
4

Using Quick-Connect Fittings

Cutting
Cut the tube square. It is essential
that the outside diameter be free
of score marks and that burrs and
sharp edges be removed before
inserting into fitting.
Connecting
Make certain to push the tubing
completely into the connector until
it comes into contact with the inter-
nal tubing stop. The collet (gripper)
has stainless steel teeth which hold
the tube firmly in position while the
O-ring provides a permanent leak
proof seal.
Pull on the tube to check that it
is secure.
NOTICE
Always test the system and
all connections for leaks prior
to concluding installation and
before use.
Disconnecting
To disconnect, ensure the system
is depressurized before removing
the tube. Push in collet squarely
against the face of the fitting. With
the collet held in this position, the
tube can be removed. The fitting
can then be reused.
Adapt-A-Valve™ Installation
STEP 1
NOTICE
Water supply line to the system must be from the cold water
supply line only. Hot water will severely damage your system.
NOTICE
Do not use Teflon tape with the Adapt-A-Valve™.
Faucet Line
Faucet Line
A
A
B
B
C
D
C
D
Cold
Water
Supply
Cold
Water
Supply
For / " Configuration
3
8
Parts List for Adapt-A-Valve™
ITEM DESCRIPTION
A Brass Adapter with black washer
B Plastic Adapt-A-Valve™ & black collet
C White Rubber Washer
D Brass Adapter with no washer
Step A – Turn off the cold water supply to the faucet by turning the
angle stop valve completely off.
Step B – Open cold water sink faucet to relieve pressure.
Step C – Choosing the configuration that fits your plumbing, attach
the Adapt-A-Valve™ as illustrated in the diagrams above.
NOTICE
Make sure that the black collet is installed in to the
ing on the Adapt-a-Valve™. Don't forget to install the white
compression washer with the
Adapters do not need to be tightened with a wrench, only
finger tight.
4
Faucet
Connection
Faucet
Connection
B
B
Line from
Cold Water
Supply
Line from
Cold Water
Supply
For 1/2" Configuration
⁄ " open-
1
4
⁄ " configuration. The Brass
3
8