Care And Maintenance; Troubleshooting; Technical Specifications - Kärcher WD 6 Premium Renovation Manual De Instrucciones

Vacuuming up coarse dirt
Illustration
 Use the coarse dirt hose, coarse dirt pipes and
coarse dirt nozzle to vacuum up coarse dirt and
stones.
ATTENTION
Coarse dirt may only be vacuumed up without the filter
bag being inserted, otherwise the filter bag can get dam-
aged.
Integrated filter cleaning system
The filter cleaning system is intended for vacuuming up
large volumes of fine dust without an inserted filter bag.
Note: Thanks to the filter cleaning system the soiled flat
pleated filter can be cleaned at the push of the button
and the suction performance can be increased again.
Illustration
 Place the handle of the suction hose in the acces-
sory compartment on the appliance head. Push the
filter cleaning button 3 x while the appliance is
switched on, wait 4 seconds between the individual
operations.
Note: After operating the filter cleaning button several
times, check the container for its filling volume. Other-
wise, the dirt might escape when the container is
opened.
Blowing function
Cleaning hard to reach locations or, where vacuuming
is not possible, like leaves from a gravel bed.
Illustration
 Connect the suction hose to the blower connection,
this will activate the blower function.
Interrupting operation
Illustration
 Turn off the appliance.
Illustration
 Hook the floor nozzle into the parking position.
Finish operation
 Turn off the appliance and disconnect the mains
plug.
Empty the container
Illustration
 Remove the appliance head and empty the reser-
voir filled with wet or dry dirt.
Storing the appliance
Illustration
 Stow away the mains cable and accessory at the
machine. Store the appliance in a dry room.

Care and maintenance

 Clean the appliance and accessory parts made of
plastic with a commercial plastic cleaner.
 If required, rinse the container and accessories
with water properly and dry them before reuse.
Clean flat fold filter
Recommendation: Clean the filter box after every
use.
Illustration
 Unlock, fold out and remove the filter cartridge,
empty dirt from the filter cartridge over a waste bin.
 In order to clean the inserted flat fold filter, knock
the filter box against the edge of the waste bin. It is
not necessary to remove the flat fold filter from the
filter box.
If necessary, clean the flat fold filter separately.
Illustration
 Unlock, fold out and remove the filter cartridge.
Illustration
 Remove the flat fold filter from the filter box and tab
it out.
 When necessary, clean under running water only,
do not wipe or brush down.
Allow to dry completely prior to use.
 Finally, reinstall the dry flat fold filter into the appli-
ance. Insert the filter cartridge into the appliance.

Troubleshooting

Decreasing cleaning power
If the suction power becomes less, check the following
points:
 Accessories, suction hose or suction pipes are
clogged, please remove the obstruction using a
stick.
Illustration
 Filter bag is full: Insert new filter bag.
Illustration
 Flat fold filter contaminated: Remove the filter box
and clean filter (see Chapter "Cleaning the flat fold
filter").
 Replace damaged flat fold filter.

Technical specifications

Mains voltage
Frequency
Output P
nom
Mains fuse (slow-blow)
Container capacity
Water intake with handle
Water intake with floor nozzle
Power cord
Weight (without accessories)
Sound pressure level (EN
60704-2-1)
Subject to technical modifications!
– 9
EN
220 - 240 V
1~50-60 Hz
1300 W
10 A
30 l
20 l
18 l
H 05VV-F2x1
8,8 kg
71 dB(A)
15