Craftsman 46133 Manual De Usuario página 11

To insert a drill bit or other accessory:
1. Grasp the rear half of the chuck (11) with one hand and use
your other hand to rotate the front half to the left, as viewed from
the chuck end.
2. Insert the bit or other accessory fully into the chuck, and tighten
securely by holding the rear half of the chuck and rotating the
front portion to the right, as viewed from the chuck end.
tORQUe CONtROl - fIGURe f
This tool is fitted with a torque adjustment collar (12) to select the
operating mode and to set the torque for tightening screws. Large
screws and hard workpiece materials require a higher torque setting
than small screws and soft workpiece materials.
• For drilling in wood, metal and plastics, set the collar to the drilling
position symbol
• For screwdriving, set the collar to the desired setting. if you do not
yet know the appropriate setting, proceed as follows:
• set the collar to the lowest torque setting.
• Tighten the first screw.
• if the clutch ratchets before the desired result is achieved,
increase the collar setting and continue tightening the
screw. Repeat until you reach the correct setting. Use this setting for the remaining screws.
ON-BOARD BIt StORAGe
a bit storage slot (5) is built-in to the area just above the battery pack for easy bit storage and access.
led WOrk light
When the drill is activated by pulling the trigger switch (2), the integrated LED work light (8) will
automatically illuminate the work area. nOte: The work light is for lighting the immediate work
surface and is not intended to be used as a flashlight.
DRIllING
• Use sharp drill bits only.
• support and secure work properly, as instructed in the safety instructions.
• Use appropriate and required safety equipment, as instructed in the safety instructions.
• secure and maintain work area, as instructed in the safety instructions.
• Run the drill very slowly, using light pressure, until the hole is started enough to keep the drill bit from
slipping out of it.
• apply pressure in a straight line with the bit. Use enough pressure to keep the bit biting but not so
much as to stall the motor or deflect the bit.
• hold the drill firmly with two hands to control its twisting action.
• DO NOT CLiCk THe TRiGGeR OF a sTaLLeD DRiLL OFF aND ON iN aN aTTempT TO sTaRT
IT. DAMAGE TO THE DRILL CAN RESULT.
• minimize stalling on breakthrough by reducing pressure and slowly drilling through the last part of
the hole.
• keep the motor running while pulling the bit out of a drilled hole. This will help reduce jamming.
• Make sure switch turns drill on and off.
DRIllING IN WOOD
Holes in wood can be made with the same twist drill bits used for metal or with spade bits. These bits
should be sharp and should be pulled out frequently when drilling to clear chips from the flutes.
DRIllING IN MetAl
Use a cutting lubricant when drilling metals. The exceptions are cast iron and brass which should be
drilled dry. The cutting lubricants that work best are sulfurized cutting oil or lard oil.
11
e
10
f
11