Craftsman 46133 Manual De Usuario página 8

c. Move charger and battery pack to a location where the surrounding air
temperature is approximately 65°F - 75°F (18°- 24°C).
d. If charging problems persist, take the tool, battery pack and charger to a local
service center.
4. The battery pack should be recharged when it fails to produce sufficient power on jobs which were
easily done previously. DO NOT CONTINUE to use under these conditions. Follow the charging
procedure. You may also charge a partially used pack whenever you desire with no adverse affect
on the battery pack.
5. Foreign materials of a conductive nature such as, but not limited to, steel wool, aluminum foil, or any
buildup of metallic particles should be kept away from charger cavities. Always unplug the charger from
the power supply when there is no battery pack in the cavity. Unplug charger before attempting to clean.
6. Do not freeze or immerse charger in water or any other liquid.
WARNING:
Shock hazard. Do not allow any liquid to get inside charger. Never attempt to open
the battery pack for any reason. If the plastic housing of the battery pack breaks or cracks, return to a
service center or collection site for recycling.
INStAllING AND ReMOvING the BAtteRY PACk fROM the POWeR UNIt
WARNING:
Make certain the lock-off button (2) (figure B) is engaged to prevent switch actuation
before removing or installing battery.
TO iNsTaLL BaTTeRy paCk: Insert battery pack into the Power Unit until an audible click is heard
(figure B). Make sure battery pack is fully seated and fully latched into position.
TO RemOVe BaTTeRy paCk: Depress the battery release button (7) as shown in figure C and pull
battery pack out of the Power Unit.
B
2
C
8