Dremel Micro 8050 Instrucciones De Funcionamiento Y Seguridad página 18

DM 2610031565 05-14-v8_8050 5/13/14 11:45 AM Page 18
887 3 HOUR 45 MINUTE CHARGER
Your Dremel Micro does not come completely
charged from the factory. Be sure to charge
tool prior to initial use. Plug the power adapter
jack onto the charging base and insert the
power adapter plug into your standard power
outlet. Place tool in charging base as shown in
figure 7. The blue LED lights located on the
topside of the tool housing will start scrolling
top/down to signal the battery is receiving a
charge. Charging will automatically stop when
the tool is fully charged. When all the blue LED
lights are off charging is complete. At this point
the battery charge light will be green. The tool
may be used even though the blue LED lights
may still be scrolling top/down. The blue LED
lights might require more time to stop scrolling
depending on temperature.
Charging Tool (Cont.)
Jack for Charging
Base Outlet
FIG. 7
Power dapter
Power Supply
The scope of the scrolling blue LED lights is to
indicate that the tool is charging. It does not
indicate the exact point of full charge. The blue
LED lights will stop scrolling in less time if the
tool was not completely discharged. In this
case the battery charge light could be green,
orange or red. When the battery pack is fully
charged you can leave the tool in the charging
base.
Outlet for
Charging Base
18