Dremel Micro 8050 Instrucciones De Funcionamiento Y Seguridad página 7

DM 2610031565 05-14-v8_8050 5/13/14 11:45 AM Page 7
1. This manual contains instructions for
battery charger model 887. Do not substitute
any other charger.
2. Before using battery charger, read all
instructions and cautionary markings on
battery charger and product using battery.
3. Charge only Dremel Micro. Other types of
cordless tools may burst causing personal
injury and damage.
4. Charge tool in temperatures above +32
degrees F (0 degrees C) and below +113
degrees F (45 degrees C). Store tool in
locations where temperatures will not
exceed 120 degrees F (49 degrees C). This is
important to prevent serious damage to the
battery cells.
5. Do not recharge tool in damp or wet
environment. Do not expose charger to rain
or snow. Water entering battery charger may
result in electric shock or fire.
6. Battery leakage may occur under extreme
usage or temperature conditions. Avoid
contact with skin and eyes. The battery liquid
is caustic and could cause chemical burns to
tissues. If liquid comes in contact with skin,
wash quickly with soap and water. If the liquid
contacts your eyes, flush them with water for a
minimum of 10 minutes and seek medical
attention.
7. Place charger on flat nonflammable
surfaces and away from flammable
materials when recharging tool. Carpeting
and other heat insulating surfaces block proper
air circulation which may cause overheating of
the charger and tool. If smoke or melting of the
charger or tool is observed, unplug the charger
immediately and do not use the tool or charger.
Contact customer service immediately.
8. Make sure cord is located so that it will
not be stepped on, tripped over, or
otherwise subjected to damage or stress.
Damaged plug and cord may result in electric
shock or fire.
Charger Safety Rules
9. Disconnect the charger by pulling the
plug rather than the cord. Do not operate
charger with damaged cord or plug; have
them replaced immediately. Damaged plug or
cord may result in electric shock or fire.
10. Do not insert tool in charger if tool
housing is cracked. Using damaged tool may
result in electric shock or fire.
11. Do not disassemble charger or operate
the charger if it has received a sharp blow,
been dropped or otherwise damaged in
anyway. Incorrect reassembly or damage may
result in electric shock or fire.
12. Before each use, check the battery
charger, cable and plug. If damage is
detected, do not use the battery charger.
Never open the battery charger yourself,
take it to a Dremel Factory Service Center,
or qualified serviceman only using original
spare parts. Incorrect reassembly may result
in electric shock or fire.
13. Dremel Micro does not accept any
attachment.
14. Do not store tool in charger. Tool stored
in charger over a long period of time could lead
to battery pack damage and fire.
15. Unplug charger from outlet before
storage, attempting any maintenance or
cleaning. Such preventive safety measures
reduce the risk of electric shock or fire.
16. Keep the battery charger clean by
blowing compressed air on charger vents
and wiping the charger housing with a
damp cloth. Contamination may result in
electric shock or fire.
17. If substantial drop in operating time per
charge is observed the tool battery may be
nearing the end of its life. Take the tool to a
Dremel factory service center or qualified
serviceman to replace battery with Dremel
original spare parts.
7