Technical Parameters - YATO YT-82901 Manual Del Usuario

PROPERTIES OF THE TOOL
The drill and screwer is a universal portable tool which does not require external power supply for do-it-yourself enthusiasts
designed to drill holes in distinct materials (e.g. wood and wood-derived materials, metals) and to screw and unscrew bolts. Its
special advantages will be appreciated by DIY enthusiasts realising assembly and fi nishing jobs. The tool has been designed
solely for domestic work and must not be used professionally, i.e. in workshops and for remunerable jobs. A correct, reliable and
safe functioning of the electric tool depends on its proper use, so:
Before you proceed to operate the device, read the manual thoroughly and keep it.
The supplier will not be held responsible for any damage resulting from the safety regulations and the recommendations indicated
hereby not being observed.
EQUIPMENT
The product is supplied in a complete state and requires no assembly. Together with the product there are provided: the recharge-
able battery and charging station (charger).

TECHNICAL PARAMETERS

Parameter
Catalog number
Operating voltage
Speed (idle)
Maximum torque
Noise level
- accustic pressure LpA ± KpA
- accustic power LwA ± KwA
Degree of protection
Insulation class
Vibration level ah ± K (drilling / screwing)
Weight
Tool handle
Maximum diameter of drilling
- in wood
- in concrete
- in steel
Type of the battery
Capacity of the battery
Charger
Input voltage
Mains frequency
Rated power
Output voltage
Input current
Time of charging
GENERAL SAFETY CONDITIONS
NOTE! Get acquainted with all the instructions below. Failure to observe them may lead to an electric shock, fi re or injuries. The
notion of electric tool used in the instructions applies to all the tools which are powered with electric current, both wire tools and
wireless ones.
OBSERVE THE FOLLOWING INSTRUCTIONS
Place of work
The place of work must be properly illuminated and clean. Disorder and poor illumination may be a cause of accidents. Do not
work with electric tools in explosive environments, or those which contain infl ammable liquids, gases or vapours. Elec-
tric tools generate sparks, which may cause a fi re in case of contact with infl ammable gases or vapours. Do not allow children
and outsiders to the place of work. A lack of concentration may result in a loss of control over the tool.
O R I G I N A L
12
GB
Unit
[V]
[min ]
-1
[Nm]
[dB]
[dB]
[m/s ]
2
[kg]
[mm]
[mm]
[mm]
[mm]
[Ah]
[V~]
[Hz]
[W]
[V]
[A]
[h]
I N S T R U C T I O N S
Value
YT-82901
12 DC
0 - 400 / 0 - 1300
30
83,14 ± 3,0
94,14 ± 3,0
IP20
III
2,390 ± 1,5 / 1,146 ± 1,5
0,8
0,8 - 10
20
-
10
Li-Ion
1,5
100 - 240
50 / 60
25
12
1,5
1