Publicidad
cC
Do not use the tilt support lever/knob
when trailering the boat. The outboard
motor could shake loose from the tilt
support and fall. If the motor can not be
trailered in the down position, use an
additional support device to secure it in
the up position.
EMU00329
STORING OUTBOARD MOTOR
When storing your outboard motor for
prolonged periods of time ( 2 months or
longer ), several important procedures
must be performed to prevent expensive
damage.
It is advisable to have your outboard ser-
viced by an authorized Yamaha dealer
prior to storage. However, the following
procedures can be performed by the
owner with a minimum of tools.
cC
8 Do not place the engine on its side
before the cooling water has drained
from it completely, or water may enter
the cylinder through the exhaust port
and cause problems.
8 Store the engine in a dry, well-ventilat-
ed place, not in direct sunlight.
EMU00334
1) Wash the motor body using fresh
water. (Refer to "MOTOR EXTERIOR")
2) Remove the fuel-line connection(s) or
shut off the fuel valve, if equipped.
from the motor.
3) Run the engine at idling speed sup-
plying fresh water to flush the cool-
ing-water passages until the fuel sys-
tem becomes empty and the engine
stops. (Refer to "Flushing Cooling
System")
4-3
GB
Publicidad
Capítulos
