i.safe MOBILE IS730.2 Guia De Inicio Rapido página 3

ENGLISH
INTRODUCTION
This document contains information and safety regulations which are to be observed
without fail for safe operation of the device IS730.2 under the described conditions .
Non-observance of this information and instructions can have serious consequences
and / or may violate regulations .
Please read the manual and these safety instructions before using the device .
In case of contradicting information, the text of these safety instructions shall apply .
In case of any doubt, the German version shall apply .
The current EU-declaration of conformity, certificates, safety instructions and manuals
can be found at www.isafe-mobile.com, or requested from i.safe MOBILE GmbH .
RESERVATION
Technical Data is subject to change without notice . Changes, errors and misprints may
not be used as a basis for any claim for damages . All rights reserved .
i.safe MOBILE GmbH cannot be held responsible for any data or other loss and direct
or indirect damages caused by any improper use of this phone .
EX-SPECIFICATIONS
The IS730.2 is a device suitable for use in potentially explosive atmospheres classified
as zone 2/22 in accordance with directives 2014/34/EU and 2014/53/EU .
EX-MARKINGS
ATEX:
II 3G Ex ic IIC T4 Gc IP54
II 3D Ex ic IIIB T135 °C Dc IP54
EU Type Examination Certificate:
EPS 15 ATEX 1 036 X
CE-designation: 2004
IECEx:
Ex ic IIC T4 Gc IP54
Ex ic IIIB T135 °C Dc IP54
IECEx Certificate: IECEx EPS 16 .0029 X
EU-DECLARATION OF CONFORMITY
The EU-declaration of conformity can be found at the end of this manual .
FAULTS AND DAMAGES
If there is any reason to suspect that the safety of the device has been compromised, it
must be withdrawn from use and removed from any ex-hazardous areas immediately .
Measures must be taken to prevent any accidental restarting of the device .
4
Temperature range:
-20 °C ... +60 °C
Manufactured by:
i.safe MOBILE GmbH
i_Park Tauberfranken 10
97922 Lauda-Koenigshofen
Germany
The safety of the device may be compromised, if, for example:
Malfunctions occur .
The housing of the device shows damage .
The device has been subjected to excessive loads .
The device has been stored improperly .
Markings or labels on the device are illegible .
It is recommended that a device which shows or which is suspected of faults
and damages is returned i.safe MOBILE GmbH for inspection .
EX-RELEVANT SAFETY REGULATIONS
Use of this device assumes that the operator observes the conventional safety
regulations and has read and understood manual, safety instructions and certificate .
The following safety regulations must also be complied with:
Inside ex-hazardous areas the covers of the interfaces and the rear cover have
to be closed .
To ensure the IP protection, it has to be ensured that all gaskets are present
and functional . There must be no large gap between the two halves of the housing .
The device may only be charged outside ex-hazardous areas using the appropriate
charger or other equipment approved by i.safe MOBILE GmbH .
The device is supporting inductive charging .
The device may be charged only at temperatures in between 5°C ... 35°C .
The device must not be exposed to abrasive acids or bases .
The device must not be taken into zones 0, 1, 20 or 21 .
Only accessories approved by i.safe MOBILE GmbH may be used .
FURTHER SAFETY ADVISES
Do not touch the screen of the device with sharp objects . Dust particles and nails may
scratch the screen . Please maintain the screen clean . Remove dust on the screen with
a soft cloth gently, and do not scratch the screen .
Charge the device under indoor conditions only .
Do not put the device in environments with excessive temperatures, as this could lead
to heating of the battery, resulting in fire or explosion .
Do not charge the device near any flammable or explosive substances .
Do not charge the device in environments with much dust, humidity, or excessively
high or low temperatures (the permitted charging temperature range is 5 ... 35°C) .
Do not use the device in areas where regulations or legislatives prohibit the use .
Do not expose the device or charger to strong magnetic fields, such as are emitted
from induction ovens or microwaves .
Do not attempt to open or repair the device . Improper repair or opening can lead to
the destruction of the device, fire or explosion . Only authorized personnel are allowed
to repair the device .
Only use accessories approved by i.safe MOBILE GmbH .
EN 5