Ugur UMD 200 HS Manual Del Usuario página 40

C- INSTALLATION OF YOUR COOLER.
Selecting the place of installation
The operating environment of the product is very important for the smooth operation of your product. While selecting the operat-
ing environment,
Do not place your product exposed to outdoor environment (on the street, avenue etc.)
Place the product at least one (1) meter away from heat resources (stove, radiator, electric heater etc.). (Picture 1)
Do not place it opposite to the air conditioner chutes, under fans and direct door and window openings. (Picture 2)
Do not expose to direct sunlight. Operation ratio will increase if sunlight comes to the cooler's glass. That means an increase in the
energy consumption.
Air intake and outlet must absolutely be fluent and free for proper operation of the compressor section of your product.
While approaching your product to the wall, be careful that there is a gap of 150 mm (15 cm) between the wall and back of your
cooler.
Ürününüzün duvara yanaştırırken duvar ile soğutucunuzun arkası arasında 150 mm (15 cm) boşluk kalmasına dikkat ediniz.
WARNING!
In very humid environments, ensure that floor and wall of the place where your product is located, is not af-
fected by water; against discharge water overflow danger.
In installations performed by Authorized Uğur Service, Authorized Uğur Service shall inform the consumer
on the suitable place for installation and make suggestion, but the consumer shall give the final decision on
where the installation will be made. This above mentioned process shall also be stated on the relevant instal-
lation form by Authorized Uğur Service. In case of any loss arising from the place of installation of the product
according to the final decision given by the consumer, all responsibility related to such loss shall belong to the
consumer.
Your device gives the best cooling performance according to the climate condition under the conditions given be-
low. Therefore, be careful that the temperature of the environment where your cooler will operate is at these levels.
EN
In commercial products:
Climate Class
Class 3
Class 4
Class 5
Climate Class of your product is indicated on the technical specification label on the product.
Temperature Range
+16 °C to 25 °C
+16 °C to 30 °C
+16 °C to 40 °C
PICTURE 1
Humidity
60% Rh
55% Rh
45% Rh
40
PICTURE 2